High wattage coils
- Thread starter rwechsler
- Start date
- th_trl_thread_readers 0
- Status
So you don't oxidize the mesh "wire" do you? I just made up a 3 inch long by 1mm wide "ribbon" to try this with, which I made by folding a piece of mesh and cutting it down to the proper width with titanium shears
Huh, I may have to give this a try tomorrow. I tore down my Ody yesterday and cleaned, but haven't gotten around to making a new coil just yet so it's all ready to go
Nice vid Rick, dude at times you look like you're suffering 
I don't understand why you're not getting good wicking at 7.4v. I'm running one of my GGTS's with twin IMR AW 18490's on a 2.5ohm coil with the standard Ody wick from COV. The coil is on a double wick on the top coil part then single wick going down the Ody ceramic channels. I'm running the setup on the short mode Ody and I too get crazy plumes of really tasty vapor. I vape usually the RAWR Strapple @ 12mg/ml so nic levels are not bad. I do crank up the juice control more than when I vape 3.7v, I would say almost close to double but never had any wicking issues.
I don't understand why you're not getting good wicking at 7.4v. I'm running one of my GGTS's with twin IMR AW 18490's on a 2.5ohm coil with the standard Ody wick from COV. The coil is on a double wick on the top coil part then single wick going down the Ody ceramic channels. I'm running the setup on the short mode Ody and I too get crazy plumes of really tasty vapor. I vape usually the RAWR Strapple @ 12mg/ml so nic levels are not bad. I do crank up the juice control more than when I vape 3.7v, I would say almost close to double but never had any wicking issues.
Here's a link to my newest youtube. I don't really go over the actual construction of the coils, but I talk about each of them and most importantly, blow insanely fat clouds
Nice vid Rick, dude at times you look like you're suffering
I don't understand why you're not getting good wicking at 7.4v. I'm running one of my GGTS's with twin IMR AW 18490's on a 2.5ohm coil with the standard Ody wick from COV. The coil is on a double wick on the top coil part then single wick going down the Ody ceramic channels. I'm running the setup on the short mode Ody and I too get crazy plumes of really tasty vapor. I vape usually the RAWR Strapple @ 12mg/ml so nic levels are not bad. I do crank up the juice control more than when I vape 3.7v, I would say almost close to double but never had any wicking issues.
2.8 @ 7.4 - 24 nic - Double Ody wick in Short Mode - I have to do small bursts, no wicking problem, can't vape it like 6V - makes me nauseus if I do - called nic sick
Nice vid Rick, dude at times you look like you're suffering
I don't understand why you're not getting good wicking at 7.4v. I'm running one of my GGTS's with twin IMR AW 18490's on a 2.5ohm coil with the standard Ody wick from COV. The coil is on a double wick on the top coil part then single wick going down the Ody ceramic channels. I'm running the setup on the short mode Ody and I too get crazy plumes of really tasty vapor. I vape usually the RAWR Strapple @ 12mg/ml so nic levels are not bad. I do crank up the juice control more than when I vape 3.7v, I would say almost close to double but never had any wicking issues.
Fixed all of my wicking problems and now it's just vaping like a freight train! I really was suffering in those 2 rips off of the 24w iAtty...DRIEST WICK IN THE GAME!
I too when I first tried 7.4v did it on a friends with 24mg juice and almost died, can't vape that crap for long, too strong for my wimpy ... 
My 12mg though is just fine. Try a lower nic dspin @ higher voltage.
You're getting old my brother, like me
My 12mg though is just fine. Try a lower nic dspin @ higher voltage. You're getting old my brother, like me
24mg would literally give me nicotine poisoning...these days I'm all the way down to 8mg from 36mg from 1 1/2 packs/day of malb reds (or lucky strikes).
I too when I first tried 7.4v did it on a friends with 24mg juice and almost died, can't vape that crap for long, too strong for my wimpy ...
You're getting old my brother, like me
Hey Capt. I think I have 20 yrs on you. hahaha I do need to reduce the nic though at 7.4 - next order from somewhere. Have too much juice right now to order more
AHAHAHAHAAHAHAHAH! Do your worst! I'll slay the fish with with 24 watts of pure Odysseus power. I'm talking about some 21st century Greek Myths!
lol, I am saying that for over 8 months now zogem. One simple example is this: Take a 6 ohm wire and vape it at 7,4 volts. Thats 9,12 watts. Will it vape well? I dont think so.
Another example is this: Take a 0,3mm fat wire and make a 3 ohm wire. Then take a 0,1mm fat wire and make a 3ohm wire too. They will give same watts under same voltage. Do they vape the same? Of course not for one more time.
Another example is this: Take a 0,3mm fat wire and make a 3 ohm wire. Then take a 0,1mm fat wire and make a 3ohm wire too. They will give same watts under same voltage. Do they vape the same? Of course not for one more time.
When I will make the GGVV module you will see what Ody can do rw. But Ody can already do amazing things like vaping at high voltage like it vapes exellent in low voltage too as you said on another post
one more great video from you buddy. I love them!!
Here's a link to my newest youtube. I don't really go over the actual construction of the coils, but I talk about each of them and most importantly, blow insanely fat clouds
Standby for when Im on my computer tonight I will release the Kraken for you
I'm honored by your praise Imeo, thank you. I'll be sure to make a much more thorough video demonstrating my coil building process and to give some suggestions on high powered vaping. Maybe I'll throw it up tonight depending on whether or not my girl stays over.
- Status
Similar threads
