- Status
I think you suggestion is correct if it is just slightly burned it might work, and it is sure worth a try.
I fill the carto like normal,slot it or drill it,put it in the tank,fill the tank,BOOM,~4mls liquid,ready to vape all day
It sounds like its still dry. What voltage are you using? What size hole is in the cart? Is your liquid a thick one? How many holes in the cart?
am using a 4.2V with DC 1.5ohm. the liquid is 50PG/50VG. having punch 2 holes on the cart.
I made one today, when I got home from a hospital visit and got 2 10ml syringes there. Easy!!!! And I am soooo bad with tools!
I did not boil. Like I said, I washed them in tepid water and dish soap.
tried doing it. after 4 drops it will start leaking from the bottom of the cart. but the top of the polyfill always seems to be dry
The top will always dry out first. As long as there's nicquid in the tank above the 'hole' and the vape is good, you should be good to go.
Oh, I forgot... Another good hint. A AA Mini-Mag flashlight body is an awesome syringe 'filler' for cutting the tubes with a tubing cutter. The body will prevent the syringe from collapsing.
Here is a tip for punching a hole in a cartomizer, I found this the easiest way for me to do it. I used a 1 inch long concrete nail as punch. Their pretty pointed & are hardened. To hold the DC cartomizer I used a thin strip of two sided foam tape stuck to a piece of wood, then taped over it with a couple of strips of masking tape. I barely lifted the hammer 8 inches. It punches a nice hole without leaving any shavings from a Dremel or a drill.
Also, after a little more experimentation with my Fluxomizer tank, I took my Exacto blade & turned the holes in the tube body into two slits. Even easier filling now.
Also, after a little more experimentation with my Fluxomizer tank, I took my Exacto blade & turned the holes in the tube body into two slits. Even easier filling now.
Has anyone come across any of the Boge cartos that have been reported to have filler issues, namely that they are packed too tightly and won't wick properly. I think I just came across 2 of them, and they won't wick for nothing. Great holes punched in, primed a bit on the top, my usual procedure, they just won't wick. The first few toots are great, then dry taste leading to burnt taste. I just put another carto in, and it is divine.
I don't have a answer for you on this one, I know some do wick better than others and hate it when you use a new one and it doesn't vape right. Aslo don't forget it you have a bad carto that has lots of juice in it, to pull the wicking material out and put in a syringe and push the plugger down and you will get all the juice back. I'm wondering how long you cut you syringes for the mods you built and what length others like if they would share with me. Also preference for the hole size to drill in the carto for the best wicking in the tube mod?
- Status
