Sorry for this. Major bummer.and here -
turns out that i left my mod in a charity shop today went back not more than 1min after realizing( i was visiting next door )and it wasn't there knowone seen it no cameras in the place
rip yihisx500 and blitz FP second sx500 i have lost
on a positive note the batteries where baddly needing rewrapped
- Status
At first I was thinking, what on earth are you describing? But u said Wismec and I googled it. Yeah it's a bluetooth speaker!
I'm kinda shocked I missed that detail in the ads. I heard about the mod, I could have gotten it without knowing it "speaks" but I feel it's too expensive for a mario mod. Glad I didn't. I love swimming but I don't think I wanna snorkel and vape at the same time. If Samsung can turn the S-PEN into a cig-a-like, maybe I'll get that. But not from Apple.
Just got through reassembling my new Pico 75W. Yes, new (received it a month ago). It came in with the power adjust rocker protruding just enough to make it rock when I set it down on a table. My others have a half mm clearance, but this one is a little out of spec. Other than that it works fine, but I'm ticky about things being built with care.
It looks like I'm going to have to shim the bottom cap since there was no way to tighten/adjust/move anything inside. It's pretty easy to remove and replace the parts in the bottom cap but there's no way other than shimming to raise the bottom cap and recess the fire button so that it doesn't protrude and cause the mod to rock and fall over a little easier when it's sitting on a table. It sits fine on a table, but I can touch it and it rocks on the fire button.
I probably should have RMA'd it when it came in, but I ignored it thinking I could fix it. I can, but it's going to require a shim once I buy some plastic shim stock at Ace Hardware.
It looks like I'm going to have to shim the bottom cap since there was no way to tighten/adjust/move anything inside. It's pretty easy to remove and replace the parts in the bottom cap but there's no way other than shimming to raise the bottom cap and recess the fire button so that it doesn't protrude and cause the mod to rock and fall over a little easier when it's sitting on a table. It sits fine on a table, but I can touch it and it rocks on the fire button.
I probably should have RMA'd it when it came in, but I ignored it thinking I could fix it. I can, but it's going to require a shim once I buy some plastic shim stock at Ace Hardware.
Last edited:
nothings that easy, the thiefs would just start cutting fingers lol or just flash the firmwareThumb print reader on the fire button
I bet a lot of vape thieves don't know what flashing the firmware means.
Cutting off fingers? This ain't medieval times. Shoot you in your sleep, maybe, but not cutting off fingers.
I would notice someone trying to do that also. LOL just saying.
OHHHH I have to get ready for work and there is an all staff pediatrics meeting and those SUCK. THEY SUCK.
Anna
Cutting off fingers? This ain't medieval times. Shoot you in your sleep, maybe, but not cutting off fingers.
I would notice someone trying to do that also. LOL just saying.
OHHHH I have to get ready for work and there is an all staff pediatrics meeting and those SUCK. THEY SUCK.
Anna
Yeah but if we see someone vaping with a chopped off finger we can give him the stink eyenothings that easy, the thiefs would just start cutting fingers lol or just flash the firmware
- Status
Similar threads
- Locked
