Janty USB passthrough Batteries

[CalPilot89]

Ok. I love my Janty pass through, but now it does not work. I suspect, and Jeff thinks the battery is bad inside. The battery inside is the same size as a AAA battery. Can I put a AAA battery in it and will it work? If not, what type of battery can I use? Jeff is sending me a replacement, but I was just wondering if I could just use regular rechargeable AAA batteries.
Anyone know? Thanks

 

[livlife]

I to have the Janty Kissbox with the usb pass through. Don't think AAA"s will work they are 1.5 or 1.2 volt. You will need to buy replacement batteries from Jeff or get them from someone else. I bought these from this website: UltraFire 10440 AAA Li-Ion 3.6V Rechargeable Battery 500 mAh CR10440 Lithium Ion they are 3.6 volt. That is what the Janty pass through uses.

 

[Cellmeister]

OK To Clear Up The Janty The Kiss Box / Joye KB Styles 3.6 Volt Special Battery Requirements:

Both KB Type Units Use The 10430 3.6 Volt Rechargeable Battery, Yes It Is AAA Size But 3.6 Volts.

It Can Be Replaced with the 10440 3.6 Volt Rechargeable Battery.

DO NOT STICK A REGULAR OR RECHARGEABLE AAA BATTERY (1.5 Volt) IN THE HOLDER & PLUG IT IN!

Further The Unit Will Not Work Without The Proper Battery In The Holder (safely).

Yes livlife That is The Correct Replacement 10440 3.6 Volt Rechargeable Battery Available in Many Places!

Hope That Helps!

Keep Vapin!

 

[CalPilot89]

Thank you both! I wanted to ask before I put one in and had it blow up in my face. I will get some backups online. Thanks again!

 

[ZambucaLu]

Look at this Cal:

http://www.e-cigarette-forum.com/fo...y-kissbox-usb-e-cable-battery.html#post128081

Lu

 

[borjis]

I can't post a new thread yet, so I'll post it here....


Who is going to be the first to make a USB pass through from a Dura-C?

(switch is already there)

so you "could" in theory just wire up long usb chord and solder it or connect
it to the switch couldn't you?

I want a non-battery DIRECT usb power source for the Dura!