Kayfun LITE

[Vagabondnurse]

Here's a teaser pic.. stay tuned for more! How's that?!

Pretty! And with the holiday appropriate red tank section no less! The new drip tip design is nice.

 

[Jerms]

There is a method to fill the KFL by taking off the top cap but you have to be careful. You have to make sure you tightened down the two chimney sections when you initially put it together otherwise when you take off the top cap you may also loosen the chimney section causing it to flood. This is more important on the Russian 91% than the KFL as I find the former is more likely to come apart than the latter.

Just start to unscrew the top cap section that your drip tip/mouthpiece goes into. Place a finger over the air hole on the bottom then continue to take the cap off. While keeping a finger over the air hole you can fill up the tank. Then put the top cap on until it just barely catches the first threads but do not tighten. Once the threads catch turn the device upside down for a couple seconds (so the air bubble can rise to the juice channels) then remove your finger from the air hole and finish tightening the top cap.

If you don't do the finger over the air hole/flip thing, when you screw down the top cap you will flood the chamber. If you need a visual of it check out the PBusardo video reviews of the KFL or Russian as he shows how to use this method.

This is how I fill my KFL 99% of the time. Quick and easy when you get the hang of it.

 

[nttdemented]

Here's a teaser pic.. stay tuned for more! How's that?!

Is that god aweful drip tip still 510 standard and removable? :-\

 

[BuzzKilla]

arent all KFL driptips 510?

 

[Vagabondnurse]

Is that god aweful drip tip still 510 standard and removable? :-\

It appears to be.

 

[qorax]

 

[vdaedalus]

This is what you want to see on the Friday before a long weekend.

Estimated delivery :
N/A
OTTAWA, ON   CA

 

[Dusty_D]

This is what you want to see on the Friday before a long weekend.

Estimated delivery :
N/A
OTTAWA, ON   CA

Aww... sorry dude!

 

[Dusty_D]

Is that god aweful drip tip still 510 standard and removable? :-\

It is removable and is a 510, but the old KFL drip tip seems to fit a bit loose in there. You might want to start scrounging around for a tight fitting or double o-ring drip tip if you have one.

 

[Mitey F]

Is that god aweful drip tip still 510 standard and removable? :-\

It's funny how polarizing something as simple as a drip tip can be. I like the new one, and think the OG KF drip tips look like a tiny little penis... and they certainly don't match ANY of the lines on the atty. I mean, all of the lines are hard angles, and then they go and put a ROUND drip tip on it?

 

[qorax]

Here's a teaser pic.. stay tuned for more! How's that?!

This driptip looks so cool, done right. Good that SM had an afterthought.
And Congrats Dusty!

 

[Bronze]

Are these genuine KFL+ still whistling?

 

[Dusty_D]

Are these genuine KFL+ still whistling?

Since I never had a + before, I was playing around with the air-control thingamabob. I noticed that it started to faintly whistle the more open it was. It could just be air whistling over the controller screw that's causing it. I don't intend leaving it that open anyway, so not too concerned about it.

 

[Bronze]

Since I never had a + before, I was playing around with the air-control thingamabob. I noticed that it started to faintly whistle the more open it was. It could just be air whistling over the controller screw that's causing it. I don't intend leaving it that open anyway, so not too concerned about it.

Updates when you have them. Thanks. Also, compare the position of the + airflow control screw to the original KFL. Thanks again.

 

[qorax]

Loving my RED as well !


http://www.e-cigarette-forum.com/fo...rd-telescopic-mod-pictorial.html#post12214503

 

[Bronze]

That's the other thing I like about the KFL. You can lay it on its side without worry. Can't say that about any other device.

 

[qorax]

That's the other thing I like about the KFL. You can lay it on its side without worry. Can't say that about any other device.

1 hundred % True√

 

[Dusty_D]

Updates when you have them. Thanks. Also, compare the position of the + airflow control screw to the original KFL. Thanks again.

Will do..

 

[nelsonm64]

That's the other thing I like about the KFL. You can lay it on its side without worry. Can't say that about any other device.

1 hundred % True√

I had one of mine leak on me when it sat on it's side for a day or so. the airhole was facing down though...

 

[qorax]

I had one of mine leak on me when it sat on it's side for a day or so. the airhole was facing down though...

I never care for where my air-hole was and none has ever leaked. I have always kept my mods with K'funs horizontally.