Let's talk hardware

Status
Not open for further replies.

DavidOH

Vaping Master
ECF Veteran
Apr 9, 2013
5,309
61,430
Ohio
I did some adding and it looks like you could build either a duel or single 18650 for about $150. did you check out the clamp and screen cradle that will fit in almost whatever you want? Opens up a lot of possibilities for a diy mod.

Screen and DNA20/30 Clamp by jonniemac on Shapeways


I'll be showing this to the guys at the B/M next time I go in.
 

DavidOH

Vaping Master
ECF Veteran
Apr 9, 2013
5,309
61,430
Ohio
I just put a 5/64 dia. 0.5mm x 0.1mm ribbon coil with 4/5 wraps at 1.3ohm and cotton in the KFL. Didn't preheat the ribbon so the first quarter tank was just ok. Then It started hitting. I don't think Serendipity ever tasted this good. And it's what I had in it yesterday. I may have to play around with ribbon wire a little more.
 

Iowa Gal

Vaping Master
ECF Veteran
Verified Member
Dec 13, 2010
9,598
28,604
Central Iowa
Well... after seeing them at Vapebash I just had to acquire a Hana Mini Mod and this morning I scored. I do however plan to sell my Provari Minis and some Bulli Drip tips so should cover the cost. It's such a cute little mod just couldn't pass it up. I got a DNA 30 which is more than I'll ever use but wanted to find a mint unit. For me, it will function like my provaris just in a smaller form and much lighter.
 

DavidOH

Vaping Master
ECF Veteran
Apr 9, 2013
5,309
61,430
Ohio
For those using cotton. How often do you change it? Or maybe the question should be when do you know it needs changed? The way this KFL is working I'm thinking of retiring my RBA and building my KFL with the nano kit for Sludge. Dang First one KFL now two and I'm thinking of getting number three. This forum is a bad influence.
 
Status
Not open for further replies.

Users who are viewing this thread