I have some 12 gauge blunts on the way. I also installed a spare kayfun o-ring into the groove between the threading and side air holes.12 gauge is 2.7mm OD.
I'm going to try it with a couple of these- they're only a buck a pop. I won't cry too much if they don't fit.
A fair layman analyst, when I'm not POing people lol; nice words though, thanksI like your style Lillie, you are a technician with no leash no holding you back
That's a really good idea! I know I've got some of thems lurking around my vape drawer.I have some 12 gauge blunts on the way. I also installed a spare kayfun o-ring into the groove between the threading and side air holes.
Any tips or tricks to share? I think an angled cut will help get the little tubes started but how long to make them, about 5 mm?I just went to ebay.com and searched for what the OP was using: 10x 2.0mm 12G High Quality Sterile Body Hoop Ear Nose Piercing Needle. Mine came from Hong Kong and fit nicely.
Any tips or tricks to share? I think an angled cut will help get the little tubes started but how long to make them, about 5 mm?
Snug means hammer and punch not needed? My needles should be here this week!The needles that I got fit snug. No angle cut was required.
Snug means hammer and punch not needed? My needles should be here this week!
Correct. I inserted them by hand and they went in snugly.