Mixing Samsung 20A 2500mAh and LG HG2 20A 3000mAh

Status
Not open for further replies.

Igoinsane

New Member
Sep 14, 2016
2
0
58
Hello all. I've been vaping for close to two years now after quitting smoking. I've always stuck with Samsung 20A 2500mAh batteries and recently ordered 4 more on ebay. Except, I received LG HG2 20A 3000mAh batteries instead. I contacted the seller and he was kind of an "A" and argued that I got a the same Amps and a better mAh rating. Since some of my mods use 3 batteries and some 2, what would happen if I had mixed these two batteries in the same mod?
 

gotch23

Super Member
ECF Veteran
Jan 27, 2011
501
644
Fukuoka, Japan
Not recommeded. Different models of batteries discharge differently, also batteries of different age discharge differently. There's diagrams of that around.E.g. on tasteyourjuice (pbusardo's website).

Using a regulated mod will likely avert most catastrophic scenarios, but it's better to be safe than sorry.

Really... only use paired (or tripled, etc.) batteries in the same mod, from the same manufacturer bought at the same time, always discharged togehter. Same, same, same, same.

What could happen? In worst case? It'll go up in flames. Just... don't do it.
 

Jim_ MDP

Ultra Member
ECF Veteran
Sep 24, 2015
2,153
2,697
I'd be more concerned that you received HG2s, a very (IMO) overpriced and now highly counterfeited battery versus the (I presume) Samsung 25Rs that you ordered.

And were told to shut up and enjoy the windfall. That's fishy.

As to your question... as explained, for several good reasons do not mix 'n match different cells and/or cells of differing age or number of charge cycles.
At the very least the results will be... unpredictable.
 
  • Like
Reactions: Baditude

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,076
71
Ridgeway, Ohio
Basic concept in "marrying" batteries is to prevent one of the batteries in the set of eventually becoming the weaker of the set. The weaker battery in a set is more prone to stress during use. We obviously don't want to place batteries under stress, as this could lead to a venting battery or thermal runaway in a worse case scenario.

Conventional wisdom in marrying batteries is to start out with new batteries of the same model and make (equals), and discharge the set equally over time. The batteries start out equally the same, and should "age" equally if used in this fashion.

You don't want to break up the set by using one of the married batteries singly in another mod and then later returning that battery to the married set. Doing so would mean the batteries will have been aged differently and can no longer be considered equal.

As a battery ages the mAh of the battery degrades, as the mAh degrades so does the batteries c rating (amp limit). So down the road, your 20A battery may only be a 10A battery.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread