Need help juice leaked out of protank

Status
Not open for further replies.

dtweedieiii

Full Member
Verified Member
May 28, 2013
67
44
Richmond, VA
About 2mls of 18mg juice leaked out of my protank 2 onto my leg. it was mostly dried up/gone, is there anything I should worry about? Go to er or doctors or am I just freaking out? The protank unscrewed itself and all the juice leaked into pocket through to leg, I wiped up with wet and dry paper towels once I found it, don't know how long, must've been within the past hour.:ohmy:
 

Scarey

Super Member
ECF Veteran
Verified Member
Sep 14, 2013
641
597
Lafayette, IN, USA
18mg? Nah, just wash it with soap, if you're really worried. It's the highly concentrated stuff that you use in DIY liquid, like 60mg and 100mg, that you have to take caution not to touch. That said, don't go pouring a 120 ml bottle of 18mg on yourself. That could certainly be problematic, but 2ml wouldn't really do much more than possible skin irritation.
 

Coastal Cowboy

This aggression will not stand, man!
ECF Veteran
Verified Member
Jun 13, 2013
5,975
21,941
62
Alabama Gulf Coast
www.ibleedcrimsonred.com
I opened a bottle of DIY liquid that I had been aging for about 10 days. I wanted to see what it smelled like and whether the stuff was ready yet. So I put it under my nose, gave the bottle a squeeze and...

Snorted a few drops of 18mg joose.

The burning lasted for almost an hour.
 

DasBluCig

Ultra Member
ECF Veteran
Verified Member
Jul 30, 2013
1,450
3,584
Chichester, NH
You should be just fine mate. Take a shower. My Protank 2 leaked plenty when I first got it all over my hands. Gotta remember to sandwich that pyrex tank nice and tight between the two end pieces!

Vape well, vape often :vapor:
Ummmm...perhaps "SNUG" would be better than "TIGHT".....;)
TOO tight, and you run the risk of compressing/distorting the o-rings that seal the tank.....result: leaks....
Ditto the bottom base that holds the coil....
No wrenches, please!!!!:D
 
Status
Not open for further replies.

Users who are viewing this thread