Need some advice...........

[kellie]

I put the screw on voltage meter on my Buzz Pro and no matter how high I turned the wheel up it read 3.29. I put in freshly charged batteries and it is still the same. I tried the meter on my OB and the meter works fine. Could the middle screw just not be making contact well with the meter? It works fine and getting tons of vapor so not a big issue just wondering

 

[Bovinia]

I'm guessing you normally vape at a higher setting than 3.29, so your BP is still hitting like you are used to? I tried my little top meter and if I unscrew it just until I lose contact, it turns off and gives no reading. You don't have a regular hand held meter to check it with do you?

 

[BuzzKill]

Are you SURE you turned it up ??? 3.29v is the LOW setting !!! ????

 

[kellie]

Yeah Mike it went up alittle while I was tunring the wheel like Bov suggested. It seems to be working fine tho. I usually keep it between 3.7 - 4.2. The meter worked fine on my OB. I just switched the carto to my OB and that does hit harder. Could something just be loose?

 

[kellie]

I fixed it YAY!!!!!! The screws were real loose I tightened them up and now I am getting correct readings!!!!! Yes Mike I used a screwdriver and did not break the wire off. I must be getting better with age LOL. You taught me well

 

[908Tracy]

Woot woot! Go kellie, go kellie!

 

[Bovinia]

Way to go Kellie!! We'll turn you into a DIY'er yet

 

[salemgold]

I wish that there were a simple fix for the faulty buttons. Both of mine have to be sent in soon
DH's BP button is set back inside the hole and mine has started to stick. I think that I got some of the bum batch that Mike was talking about.

Oh well, at least I have a few OBs to use while I wait for them to replace the buttons

 

[Bovinia]

Bummer Salem I wish there was an easy fix too!

 

[salemgold]

Bummer Salem I wish there was an easy fix too!

It's okay. Like I said, I do have 4 OBs to get us by until we get them replaced so we won't have to go without

 

[5cardstud]

Sometimes they get stuck under the body of the Buzz. When I had mine apart I made that hole a size larger then had the new controller put in. Try moving it out from under with a pin if that's the problem.

Glad you got your problem figured out Kellie.

Check this out. I was referring someone to the notcig site and this is where we ended up.

 

[Wharf Rat]

Forgot the S

 

[5cardstud]

All this time and I forgot the s. Duhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh Guess I'll be known as 5card tud from now on.

 

[FranC]

Congrats on your self-fix Kellie.

 

[Bovinia]

LOL 5C, I noticed you had been playing with your avi, but I didn't notice the typo.