- Status
Vaperev carries them for $8 if I remember right.
Sent from my EVO using Tapatalk
Sent from my EVO using Tapatalk
Well, not cheap and currently out of stock, but this is the only place I'm aware of..
http://shop.vaperev.com/devices/mechanical/atmomixani/atmomixani/nemesis-replacement-pin.html
My Bagua clone switch is better than Nemmy switch.
Took some fiddling but my Nemmy switch is OK now.
I stealth drilled Nemmy and Bagua so I can blow through them in hopes they won't blow on me.
I'm digging that media blasting on the Nemmy and AGA-T (I think that's the atty). I'd media blast my whole Nemmy clone and dripper if I had access to a blaster. Nicely done!
How have you been liking those INR's? Could you share your coil build and your thoughts on the battery performance? These are on my short list when my Panny CGR's start showing signs of age.
That's cheap compared to what I paid for one from Greece. They didn't start carrying them till 2 days after I had to order one. Was $42 with the shipping from Greece.
Sent from my EVO using Tapatalk
Sent from my EVO using Tapatalk
I'm digging the media blast too; more friction for lock flick and cap removal. Media blast DT feels nice to the lips.
Samsung INR 18650 20R batts are outstanding. Great performance from 1 amp to sub-ohm. Bottom is flat which is important. Heat shrink wrap extends 1/8" over bottom which is important. My only question is do they M-80 pop or smoke bomb hiss during thermal run away event. I may just induce thermal run away on all my used cells in the future to get an idea how they handle worst case scenario.
I use cotton dual wicks on all my RTAs.
Attachments
I no longer use the 6 mm locking pin because the switch actuates smoother without it.
that's interesting…what's the pin actually supposed to do anyway? I'll try it without it, never have.
Vaperev has them sometimes, but for a quick fix stick a toothpick in and snap it off. You could also buy a 5/16 brass rod and cut it to size.
As far as removing it, I tried and the button just spun around. Just my experience.
Pin locks button to the threads so you can remove batt slack by cranking button tight.
I toss the pin.
Leave a tube gap at mid tube or at top of tube.
Turn Nemmy upside down.
Tighten switch till starts slipping.
Then tighten mid/upper tube gap to remove batt slack.
I just ordered a set. $0.90... Worth a try.
Listing says 13mm*9mm*1.0mm which is different than the ideal size others have posted.
I got curious and removed the pin, I couldn't screw the switch into the tube as the brass just kept turning so I decides it would be easier to stop there... I don't want to have a stuck switch that doesn't come off
I'm using feather touch cut spring and have plenty of friction w/o pin.
I suspect insufficient friction when my magnets arrive.
The feather touch spring is a pleasure to use; just remember to lock.
I had a spring similar to nemmy spring.
Nemmy spring will work if don't have any spare springs.
I cut spring a little at a time until switch actuation light enough for pleasure; feather touch.
I also cut springs in bagua and omega clone and they are pleasurable as well.
If spring is cut a little short and device fires when sit on desk, no worries. Just add a washer spacer under spring.
- Status
Similar threads
- Locked
