- Status
One Picture? What a Tease.
You keep doing Vids like that and It's Back to the Basement with you. Back to Basement with NO Cheetoes.
LOL.
Well allllrighty! They look like Fluxos, except no more nasty rubber rings. WOOT
the inner plug was redone as you can see with a long tube, they made the slits better so they should wick just like vision.
much easier to remove the inner plug as well if need be, alsi the ceramic cups are now burned after baking,
much easier to remove the inner plug as well if need be, alsi the ceramic cups are now burned after baking,
YA, no money shot, you know better, didn't get to be a "bad" clown with that vid
After all this time you still haven't let him out of the basement?
I think Bad mentioned earlier in the thread (or in a different thread) that they've been shipped from the factory and should be arriving soon. Then they just have to inventory, etc. and get them posted. My guess is a couple weeks - looking forward to trying them!
Back on page 5 of this thread he said they were shipped and was estimating they would be up on the site in a week, but that was over a week ago already. They must have been delayed or gotten stuck in customs I guess. Too bad these have taken so long. I was down to my last couple and got nervous about running out so ordered some CE2 ultimates I saw on sale from another vendor the middle of last week. Unfortunately they only had 2.4-2.6 ohms and I took a chance and got them anyway and now I'm regretting it. The first one I took out of the box just delivers a burnt taste and is totally unusable. Not a wicking problem, it happens even if I drip a few drops right on the coil. The second one I tried was better, usable, but still burns too hot for my taste. I haven't broken out my meter yet but I'm guessing the ohm rating on the first was outside of spec. Normally I don't go lower than 2.8 ohms and tend to prefer the taste at 3.0 to 3.2 range. Anyway, lesson learned and now I'm in the market for these again when they come in. I think to be safe I'll wait for feedback from a few folks first though since these are new. It took quite a few iterations to get the CE2 right. I'm keeping my fingers crossed that they'll get these CE2 supremes right the first time.
yes they shipped a order but it wasnt for the ce2 plus line, they shipped days later our main order, that is on its way, still in hong knong doing its dance.
the new ones remove all plugs except a new easy fill, isnt much to it, better vaping all around and ease of use is finally here, use any drip tip, the build on them has always been top notch since the new base and tube and now they even preburn the ceramic
the new ones remove all plugs except a new easy fill, isnt much to it, better vaping all around and ease of use is finally here, use any drip tip, the build on them has always been top notch since the new base and tube and now they even preburn the ceramic
In that case I'm glad I went ahead and ordered a couple of other things I needed this morning. Will you be getting more of the liqua juice in also. I ordered a couple of the smaller size bottles you have to try but even the strength I wanted in that was out of stock.
I plan to be an early adopter (like as soon as they go on sale) so I hope so too.
I've had exactly 1 problem with a Fluxo Deluxe out of the 15 I've gone through (leaking out the bottom on a single carto, the other 14 have performed flawlessly), so I have great confidence in those. Assuming the only change in the Supreme is the new top seal, I think they'll be fine.
- Status
Similar threads
- Locked
- Locked
