Nope. I think the plastic taste I'm getting is like you described. From the plastic tank chambers. It's very faint and if the flavor of the juice was closer to 100% then I probably wouldn't even taste it.
Yes i have the all the sides squared up, flat side to flat side curve side to curve side. I filled three tanks and all three leaked and it only leaks when I set it down after I vape. I wouldn't mind if it just leaked a little but it leaked alot and it drips down the side of the battery that is facing down. I just saw a post by somebody to take out the circular pieced cut out from the tank that got pierced, hope it works. Thanks
I do not recommend taking off the CHAD. I did this on 4 tanks and all 4 leak. On the tanks I did not remove the CHAD from, none leak.
I would look into maybe the wick bein pushed too far down into the needle, or your tank not being pushed fully on to the needle.
any tips to stop the leakage? The juices are coming out of the bottom of the atomizer and seeping through the vent holes, I seen a couple of people posts about tank leakage but non on how to prevent it. any thoughts/tips?
Is there plans for a LR tank atty? The vape from this is just too cool for my tastes.
Look for the "A" style drip tip designed to work with the cone shaped ego atty. It seems that should fit, if they are the same size as the original cone atomizer.
Joye eGo Aluminum driptip in 5 colors(Type A) [Driptip] - $2.00 : Healthcabin Electronic Cigarettes - Wholesale and Retail
Yes, that fits perfectly.
yes, a 1.8 ohm LR tank atomizer version is coming soon, probably end of february...
i heard a 510 tank/cartridge (working with any 510 existent atty) is coming too via joyetech as well, without a filler pad (like the 'smart tanks' that are out there right now) with just a silica wick.
I was blowing out some condensation from my eGo-T atty and my wick disappeared apparently onto the coil. Didn't notice it gone (well most of it - the mesh and a few strands were still there) until my tank emptied rather quicker than anticipated. Like a few seconds.
Got into check it and found the wick charred a little and not looking too healthy. This stuff must cost a fortune cause they didn't use much of it lol
I tried replacing it with cut off wicks from my CE2's. It took four strands to fill the needle hole adequately, but it wicked far too slow for my liking.
Yesterday I broke open an used Joye Ego-MegaCarto and snaffled the wick out of it. It looks similar and is about the same length. It too is separate strands and rather difficult to thread through the needle so I used some of the atomizer wire wrapped spirally around the threads and that got it through much easier. I then fluffed the threads at the bottom a little and squared them up with a quick snip. Snipped the raggy bit on top too to make it look like the real thing. I then put some of the e-juice I had in my tank onto the mesh ring around the atomizer, a drop on the atomizer itself and a few drops on the wick.
Put the needle/wick plate on the end of a tank and pushed it home, into position. I lined up the wick to go across the atomizer so some wick would go over both sides.
The upshot is it works. Better than the CE2 wicks but still not quite as good as the original. I get slightly dryish hits every four or five drags, but I do quick vape. I would have liked another strand of the ego atty wick but that will have to wait till next time. I am persevering for a while as I have read in this thread that sometimes they can come good again after a tank or two. Probably when the mesh reservoir gets the optimum amount in it to keep the wick refreshed.