They are 2.8 to 3.0 , but they all operate very similarly...They perform best at lower voltages and tend to get a burndt tatse at over 4.5ish...Thanks
Drew
Drew
NHaler Support thread and Coupon Code!
- Thread starter Drewsworld
- Start date
- th_trl_thread_readers 0
- Status
what happened to the coupon code? Did I miss something? Is something in stock hence the inactivation of the code?
All the horizonatl coil cartos I have tried below 2.6 get an immediate burnt taste...I stick with verticals for 2.0 ohms. Thanks
Drew
The coupon will be reactivated by tommorow,and the site has been very quirky this week. I will check the back tomorrow and see if I can figure it out. Thanks
DRew
Drew....want to order one of your "ato-miser" rebuild-able attys but it will only let me select the 2 kit option. nice as that would be, $75 is about my budget limit, not $95. (was thinking 1 kit plus an extra set of wires/wicking). any reason why I can get 2 but not 1? thanks in advance for answering!
It's working. You have to have >$40 in the cart but I just tried it and it works fine.
I need a battery/charger expert...
I just received the XTAR WP211 Charger. I have 2 "Nhaler KICK battery IMR 18650 1800mAh 3.7v purple skin", that came in the Kicked Xhaler kit, last week. The batts are flat top. The spacers must be removed from the charger for the batts to physically fit. The chargers contacts at the top, +end, once the spacers are removed, will not make contact w the + end of the batts, because the batts are flat tops the skin causes the + end to be slightly recessed. The spacers have a bit of a nipple that would contact this recess, but with spacers removed, the contact point that is left exposed goes all the way down to make contact w the skin not the + end.
Does that make any sense. I just had my wife double check my theory and she agrees. (not that she's an expert, but this is pretty simple physics). I can not get a red light. The batts meter at 3.63ish. When placed in the charger the lights stay green because they are not making contact.
I just received the XTAR WP211 Charger. I have 2 "Nhaler KICK battery IMR 18650 1800mAh 3.7v purple skin", that came in the Kicked Xhaler kit, last week. The batts are flat top. The spacers must be removed from the charger for the batts to physically fit. The chargers contacts at the top, +end, once the spacers are removed, will not make contact w the + end of the batts, because the batts are flat tops the skin causes the + end to be slightly recessed. The spacers have a bit of a nipple that would contact this recess, but with spacers removed, the contact point that is left exposed goes all the way down to make contact w the skin not the + end.
Does that make any sense. I just had my wife double check my theory and she agrees. (not that she's an expert, but this is pretty simple physics). I can not get a red light. The batts meter at 3.63ish. When placed in the charger the lights stay green because they are not making contact.
- Status
Similar threads
- Locked
- Locked
- Locked
