Odysseus official

Status
Not open for further replies.

Vaporologist

Vaping Master
ECF Veteran
Verified Member
May 26, 2010
3,192
1,207
Epic Journey
All right guys, I thought I was all ready for the ODY but now I'm a little confused about the bottom o-ring which goes under the nut on the center poll... In his videos, Imeo pushes the o-ring all the way up against the bottom of the nut. But in this video Odysseus instructions (greek) 1,7ohm - YouTube (at 2 min. 30 sec.) the o-ring is placed in the small cut or groove at the bottom of the center poll which is a few mm below the nut.

So which is the correct way to assemble? Or does it even matter?

Thanks.
 
Status
Not open for further replies.

Users who are viewing this thread