Also do you carry just the spacers for the WPII charger? I would need a couple more so I could charge both of them 
So the kit doesn't come with the AW's?
I much more prefer the Panasonics over AW but appears there are no Panasonics in the 186350. My stock/AW 18650 took a back seat once I discovered the new Panasonic IMR 18650's.
Going to probably purchase the single unit and batteries if that is the case with the kit coming with the stock batteries until panasonic ones come out.
Also do you carry just the spacers for the WPII charger? I would need a couple more so I could charge both of them![]()
sorry for not being on (and LD for now being on the show) lots of issues to deal with here lately.
No problem didn't even expect answers as quick as I got them from you
Glad to see a vendor responding as quickly as they can even when their life is in chaos. I will be putting in order probably this weekend as I am going through the "need a new toy fever". As usual when I go through this I end up with another mod put away to never be seen again.
sorry for not being on (and LD for now being on the show) lots of issues to deal with here lately.
5. It should have a built in 510 connector, I just know that sooner or later I wil loose it and then what? Can I replace it with any stock 510/ego connector?
you should see my discard box![]()


They should be the same CE3 XL that others carry. What have you tried so far? I'll tell you what works for me, pulling the coil up and lining it up with the slots. Most of mine came with the coil pushed down below the slots. This was causing the wicks to not properly cover the holes. It was also causing flooding. I took a paperclip and make a very small 90 degree angle at the end. I then placed it under one side of the coil and very gently pulled up. I repeated the process on the other side until the coil was even with the two slots. Once I did this, the vapor increased, the flavor increased and the flooding stopped completely. If you haven't tried this, give it a shot![]()
I managed to get a pair of 18350 1200mah bats into my V8 using a flat feeler gauge to hold the sping down while I slid the bats in place. VERY tight fit but they are in and working.
that's a lot of power in a small package, what brand are they?
Id be careful if I were you, sounds dangerous!!!

Are the 1200s protected? Id be nervous to use anything besides AWs or Pannys.A
