Official Squape R[eloaded] thread!

[nj1001]

^^^^

I can't find who to give my money to!

For...? The SX flask? I tossed my email onto their site a few weeks ago to get notified when something happens. Last week I got an email response giving me a password to the site where they had em up for $270. I found out from somebody else on here that contacted them that this was part of an initial run of 300 which were sold on their site. Shortly thereafter they're going to make more for masses/retailers.

 

[drippaboi]

Lucky dog you Looks very nice ... much nicer than my ipv3 which I keep around just for the dual batteries. Plus I've always wanted a flask ... time to start collecting nickels!

Sitting on my counter are spools of 28 & 30 awg tempered Ni 200 from Lightning Vapes.

I prefer this to the tempered from Stealth Vapes.

I'm curious to know what about it you like better?

 

[jazzvaper]

Lucky dog you Looks very nice ... much nicer than my ipv3 which I keep around just for the dual batteries. Plus I've always wanted a flask ... time to start collecting nickels!



I'm curious to know what about it you like better?

Objectively less springy. Subjectively no breakin time.

 

[drippaboi]

Hmm honestly I wish it was that simple. Any ideas about the air pockets though? It's very annoying and I'm certain that's what causing the serious flooding.
It has to be that there isn't a proper vacuum seal inside or something? You can see air bubbles coming out of the deck too (got the bell vape cap on) I checked the o right and that looks like it is in good condition and also the coils are perfectly centered with the wick nicely flowing down.
To avoid flooding i started making the coils longer than the cup (had to go up a size in the wire department, 0.37mm wire) which solved the issue but now it's just throwing air pockets during my drags.
Any other suggestions?

Sent from my Passport using Tapatalk

think you can try to snap a few pics? The bubbling and air pockets ... are you getting un-vaporized juice hitting your throat/tongue on the draw? if its flooding/overwicking you might be getting juice caught in the chamber and chimney. Juice really sticks and builds up on the emetal coating.

Is your vapor check after wicking giving a good smooth vapor? A "popping" coil that sends those little streamers of juice all over don't make for a smooth vape imho (though it looks really cool ! )

 

[Riblet]

The Mink 155 Drip tip look pretty good on the SquapeR/Bell

 

[DaveP]

I've seen the in depth review by PBusardo and the Sqape Reloaded looks good. Who makes the best clone? How does the flavor compare to the Kayfun 3 and 4?

 

[Bhoot]

The Mink 155 Drip tip look pretty good on the SquapeR/Bell

Rib...what bell cap is that? I'd like a plain see through one but only see the one which is masked and made of some kind of plastic. Ur one looks like glass and really nice[emoji14]


Bhoot

 

[Riblet]

Rib...what bell cap is that? I'd like a plain see through one but only see the one which is masked and made of some kind of plastic. Ur one looks like glass and really nice[emoji14]


Bhoot

It's a Chris Mun Bellcap and its
Made from frosted PMMA, I polished it clear.

 

[Bhoot]

It's a Chris Mun Bellcap and its
Made from frosted PMMA, I polished it clear.

How do you polish it clear? Do I need any special sand paper or anything?


Bhoot

 

[Riblet]

How do you polish it clear? Do I need any special sand paper or anything?


Bhoot

Just plastic polish on a paper towel.

 

[nj1001]

Bell cap + extension

 

[nj1001]

& its the exact same size as the original

 

[Bhoot]

Bell cap + extension

Do I need a drip tip adapter? Really like my cherry vape driptip.


Bhoot

 

[drippaboi]

It uses a standard 510 for the DT

 

[Bhoot]

Just checked cloud9/creme. Out of stock. Where can I find one for the normal reloaded? Falling for cap[emoji17]


Bhoot

 

[drippaboi]

when I was at the StattQualm site last night they still had some in stock - and bases were on sale for $50 ... picked one up to piece together Squape #3 ! (plus those center pins and a D deck just for fun) I was never aware of a bell for the full R, though there was one for the R Nano kit (but that doesn't help )

 

[Bhoot]

Ended up getting a stro mini v2 RDA. Next vape I am think the bell cap with Rs chimney will do very nicely. Will wash the frosting off and keep it looking clean. Thanks drip guys.


Bhoot

 

[nj1001]

I do dig the cap....
...but, I'd dig it a lot more if it were glass

 

[nj1001]

And at StattQualm, the bases are $69 now.
At Cloud9/Creme they're $81!

These prices are pre-shipping totals however so they might not be far off once that's factored into the mix.

 

[drippaboi]

Just a couple of squapes hangin' around ... Bell cap on the Xvostck makes for a much easier daily driver.