I have 2 RM2's, one stock and the other drilled to 5/64th's, right now both with 1.0 ohm builds in them on a Mini and a Woodvil. I like the larger hole's due to my long lung hits (my VA Cyclone is 7/64th's that is even better, the IGO-S to 5/64th's), but the stock is working OK as is. Even so it will be drilled out when I get to it, probably to something around 5/64th's willl be plenty since I don't run sub ohm on the Woodvil.
Ohms question
- Thread starter Sloth Tonight
- Start date
- th_trl_thread_readers 0
- Status
You can use the line but I think Trunker and I should get signed copies of the album
All reo owners should own at least a cheap drill! Although I did "hand" drill mine to 1/16th lol, and I own about 7 different drills.
It shouldn't take too long, you will like it for sure
It shouldn't take too long, you will like it for sure
.... *vape break other REO* ....hands are sore. LOL
Just how dull was that bit.....lol
think it's pretty dull...still drilling
lol it took me a minute. all of mine are drilled out to 1/16 and I absolutely love them. I'm fairly sure I recommended you do this the day you got it lol but anxious to see what you think about it.
think it's pretty dull...still drilling
You did wrap the tape around the right end didn't you
just wrapped tape around the part im holding...and it keeps sliding up lol x.x
kinggirl you did - and i've just hesitated out of fear LOL
kinggirl you did - and i've just hesitated out of fear LOL
Understandable! But like they said in previous posts, 1/16 is hardly any bigger than stock. It's just enough though to really open it up.
hey i'm a sloth sloths move slow
and vape a lot while doing so! (and rhyme--bam)
and vape a lot while doing so! (and rhyme--bam)
My recommendation at this point is go out tomorrow and buy a file. If it's taking this long your bit is shot. With a file it'll take about 15 seconds.
- Status
