Mine doesn't have any overhang when full,with the seal removed.I don't even know for sure what that seal is for,i can only assume it maybe helps seal around the top of the stock bottle when it's pushed up,or possibly to keep the bottle from sliding down,i really have no idea though,just guessing haha.
- Status
I just ordered two of these with Hadaly clones to sit on top. 
If your looking for a heavy single 18650 squonker, I think a Coppervape solid BRASS mechanical mod weighs in much much more then these little Pico units do. (I have one)
If your looking for a heavy single 18650 squonker, I think a Coppervape solid BRASS mechanical mod weighs in much much more then these little Pico units do. (I have one)
I don't have the squeeze 2 yet,so not sure those bottles would fit it anyway.Does the s2 use the same bottle as the v1,or does it already come with a silicone bottle?
I agree,i think the brass Coppervape probably weighs as much as about 10 picos haha.I love my CV's though,i have the black,brass,and bare aluminum versions.I just ordered two of these with Hadaly clones to sit on top.
If your looking for a heavy single 18650 squonker, I think a Coppervape solid BRASS mechanical mod weighs in much much more then these little Pico units do. (I have one)
My mistake, I thought this was about the Squeeze 2's (these days the S2's are what's always in my minds eye, not the S1's). I have 2 Squeeze 1's as well, and have around 20 extra factory bottles for them.
The S2's bottles system is very different from that of the Squeeze 1's, and no they are not interchangeable at all. I was assuming the silicon sleeves you were mentioning could be used with the proprietary offset from center SS caps of the S2's that you never have to take apart to fill. IMO the S2's have the easiest to fill/leak free removable bottle system yet in any squonk mod. Good pictures of their bottles are hard to come by, but I found this one that gives an idea. It's offset because the SS feed tube is also by design offset to the back of this place so when you squonk it is well out of the way to allow a full squonk without pushing on it (or bending/damaging it).
Guys, anybody for the Wasp Nano? It'll be a gift for a friend, and since I don't have one I think it'll fit and make one great first time squonker.
I’ve got one. It’s not bad at all. I found I prefer the pulse, primarily because of the mouthpiece
I've got a couple of them,nice rda's.I have 1 on my squeeze,looks good together.I would suggest putting a 510 drip tip on it though,the little nub of a tip that's molded into the cap is fairly close to the coil,but a normal drip tip makes it a great little rda.
I knew I had seen it somewhere, paired with the Drop Solo! I already bought the Squeeze, the Solo will be in in a couple of days. Any build ideas to make the most out of the squeeze? How many ohms? Thanks!
I have a Wasp Nano on one of my Pico Squeeze mods. As a lung hitter I mostly run dual coil atty's and need more air than it offers. But the WP works good'nuff for my intended use for these little shirt pocket carry squonk mods (short wee hours of the night errand runs). With the 4mm RxW build I put in it I had to add a DT to it though to fend off the spit back that build can muster.
The other Squeeze runs a Serpent BF with dual Claptons. I also have a custom console drink cup carrier for them that 2 of my 4 Pico 75 TC mods will also fit in.
- Status
Similar threads
- Locked
