Precise ELA Telescoping MOD by Super-T Manufacturing PT 2
- Thread starter anavidfan
- Start date
- th_trl_thread_readers 0
- Status
Hi David,
I would like to buy a 20x1 extension tube as soon as possible - when do you think that might be?
The ELA is such a versatile mod - this would be the icing on the cake.
In the meanwhile I'll be using my Precise Plus's, and the 20x1 attys will have to wait on that extension tube.
I am looking forward to this piece as well. I just keep wondering if the top of the tube is going to need a flange?? I'm sure David will have put it through its paces before it's up for sale.
The ELA V1's button horns have a rounded edge where they transition vs. the ELA V2's edge that has a sharp corner where it transitions... What do you think about softening the corners edge on the ELA Ti's horns...? Would that be possible without sacrificing stability when standing upright? Just a thought.... 
Last edited:
The ELA V1's button horns have a rounded edge where they transition vs. the ELA V2's edge that has a sharp corner where it transitions... What do you think about softening the corners edge on the ELA Ti's horns...? Would that be possible without sacrificing stability when standing upright? Just a thought....
No problem, we can chamfer them a bit more for you!
Fyi, we started machining on them today! Should have them all machined in about one week.
Chamfering then a bit would take the sharp edge off--but would it compromise upright stance?
I will let you decide what would be best...
PS.
Product: Precise ELA V2 Telescoping Mod - Titanium
In stock: 8
Don't miss out.... !!!
Last edited:
Great! That little sharp edge is the one thing, the only thing that bugged me about the ELA V2. It gets you once in awhile and makes the otherwise super button uncomfortable.
Chambering then a bit would take the sharp edge off--but would it compromise upright stance?
I will let you decide what would be best...
I wondered about the stance too. We will see.
If you have any sharp edges, you can chamfer them off a bit, you won't hurt anything.
I know what you mean...
No I couldn't-wouldn't do any Ti work myself, I might mess it up.... David if its no big deal go ahead and slightly chamfer the edge for me....I sent an email to Supertmanufacturing@yahoo.com Thanks...
Last edited:
I didn't mean on your TI, I was referring to anyone with an existing stainless
Last edited:
I didn't mean on your TI, I was referring to anyone with an existing as
Ok you had me worried...lol
At pain in the .... as per usual. Coming along. Working on the top caps tomorrow.
Just an update on the Titanium ELA's. Machining the bodies now, should have those done today. We have the Compression Ring, Compression Band, Extension Tubes and Adjustable post holder done. Will start on the caps later today(was going to do those last week, but did the compression rings and bodies first), the bottom caps tomorrow and finish with the accent rings on Wednesday is the goal.
The Titanium Bodies are done, now working on the TI bottom cap. Should have machining all finished this Wednesday. There are only 6 left of these (20 total being made). Don't miss out as we won't be making these again in Titanium due to the high cost and difficulty of manufacturing them.
The ELA V1's button horns have a rounded edge where they transition vs. the ELA V2's edge that has a sharp corner where it transitions... What do you think about softening the corners edge on the ELA Ti's horns...?
Don't forget to slightly round (chamfer) the edge of the bottom caps horns... Thanks....
- Status
Similar threads
