Protank draw???

[bunker0617]

I've found my Nirvana tank... The kangertech Protank love the quality, but is there any way to mod the draw tighter? Just a little too airy for me.

 

[Plumes.91]

I think your supposed to break a tooth pick off in 1 of the airholes.

 

[InTheShade]

I think your supposed to break a tooth pick off in 1 of the airholes.

Dunno if that works for a pro-tank, but that does work like a charm on a T3 / MT3.

 

[sonicdsl]

You can get an airflow controller ring (aka airflow regulator), available at a few vendors. Basically it fits between the battery & Protank, and you twist until you find your sweet spot.

 

[The Ocelot]

I use little notebook paper reenforcers.

 

[iPWN]

You can get an airflow controller ring (aka airflow regulator), available at a few vendors. Basically it fits between the battery & Protank, and you twist until you find your sweet spot.

+1 for you sir !

 

[KerryK]

You can change out the coil for an evod coil. Just take the top stem off the pro tank coil and put it on the Evod coil. Draw is tighter and the ohm is higher.

 

[bunker0617]

Will be ordering my air flow regulator tomorrow...

 

[InTheShade]

I use little notebook paper reenforcers.

love it

 

[Katya]

I use little notebook paper reenforcers.

Here's what I use!

 

[whit77]

Blob of candle wax works well, and semi permanent

 

[mad maori]

use evod head-no need to, dont change the stem, the evod as is will be fine. also if your into re-wicking your own coils 3.5mm wick when wet will tighten up the draw. i found it works real good if your mod has a top ring with no air flow channels. my old epic storm works really well with the protank. also another option is a 510-ego adapter and use the beauty ring that came with the tank.

 

[shawnavonsr]

I found adding in 2 strands from a 2mm wick to tighten up the draw, stop the flooding and stop the leakage to the battery. Just not too much or it will choke off the wicking and will get dry burns.