Random DIY mixing and More

Territoo

Diva
Supporting Member
ECF Veteran
Verified Member
  • Jul 17, 2009
    7,729
    38,111
    Texas
    I did get my mile walk in this morning and I had to zip up my swaeatshirt. Was pretty chilly.

    Fran, I'll give you some of my heat, if you give me a little bit of chilly. The high today is 99⁰, then we get into triple digits for the rest of the week. I haven't seen a sweatshirt in months, only shorts and t-shirts.
     

    FranC

    Long time vaper.
    Supporting Member
    ECF Veteran
    Verified Member
  • Oct 1, 2010
    195,741
    646,481
    New Hampshire
    Fran, I'll give you some of my heat, if you give me a little bit of chilly. The high today is 99⁰, then we get into triple digits for the rest of the week. I haven't seen a sweatshirt in months, only shorts and t-shirts.
    Good afternoon Terri. :) I think I'll keep my cool. You live in a hot place so you can expect the hot weather.
     

    gloopdegurp

    DIY Hack
    ECF Veteran
    Feb 3, 2022
    2,751
    12,373
    58
    Pennsylvania, USA
    Yesterday I fired up my Serpent SMM rta for the first time in a while. I put a new build in it but think I might need to do it over as the flavor doesn't seem on point using a tester that I started in a different tank as well as a commercial liquid that I know pretty well.
    The cotton seems fine - no dry hits and not hitting the deck. I just trimmed it a little to see but that doesn't seem to be helping. It looks to be positioned right for the airflow. I might need to try a bit smaller coil in there.

    I did watch a build video and looked at pics before I put this new build in but guess I flubbed it a bit.
     

    FranC

    Long time vaper.
    Supporting Member
    ECF Veteran
    Verified Member
  • Oct 1, 2010
    195,741
    646,481
    New Hampshire
    Yesterday I fired up my Serpent SMM RTA for the first time in a while. I put a new build in it but think I might need to do it over as the flavor doesn't seem on point using a tester that I started in a different tank as well as a commercial liquid that I know pretty well.
    The cotton seems fine - no dry hits and not hitting the deck. I just trimmed it a little to see but that doesn't seem to be helping. It looks to be positioned right for the airflow. I might need to try a bit smaller coil in there.

    I did watch a build video and looked at pics before I put this new build in but guess I flubbed it a bit.
    Always some sort of problem. Hope you get it figured out.
     
    • Like
    Reactions: gloopdegurp

    Users who are viewing this thread