Smok Xpro BT50W

[MacTechVpr]

If a Hana and ipv had a baby. .

Well apparently they did! LOL

I just picked one up. Ive got an Atlantis on it and it works great. As for people talking about it getting hot, when I was talking to the shop owner, who uses one, he said that they really cook when they crank past 30 and that .3 or lower is starting to push these. Caged did you switch out your rda coil after the taste? Just from talking to the shop owner it sounds like it may have burnt up a coil.

Honestly for my first Mod and it being authentic, I dont think I could have done much better for the price. I can see this being my everyday (I still want to pick up a decent mech)

As for the delay I was told that its there so you can turn on the device and change specs, or go to the menu, before it actually fires. I find it sort of annoying though. Could have made the locks and menus the +/- buttons and not had the delay

Both my IPVS and BT50W do exceptionally well at 45W @ .2Ω but I find the power delivery to seem smoother for the latter as well as the vape. After more than a week with both I'd say the Smok's an excellent product. The form factor's great in the hand even as the IPV looks a bit dressier. I should note in both instances all topper's were tensioned micro's which tend not stress the power source as much At lower power levels the BT50W seemed to yield a better flavor result on the new Mini Subtank. Plus I love the clicky button!



Good luck.

 

[k0shi]

I had my bt50 for about a month now and I love it with my Atlantis but I can't really get it to fire anything lower then .5 which was disappointing to me since it was marketed to fire down to .2


Sent from my iPhone using Tapatalk

 

[k0shi]

Well apparently they did! LOL



Both my IPVS and BT50W do exceptionally well at 45W @ .2Ω but I find the power delivery to seem smoother for the latter as well as the vape. After more than a week with both I'd say the Smok's an excellent product. The form factor's great in the hand even as the IPV looks a bit dressier. I should note in both instances all topper's were tensioned micro's which tend not stress the power source as much At lower power levels the BT50W seemed to yield a better flavor result on the new Mini Subtank. Plus I love the clicky button!



Good luck.

What atty are you using with this .2 build?! I tried both my stillare and mutation x v2 and I can't get it to fire anything lower then .5 it just says check atomizer even with a fully charged battery


Sent from my iPhone using Tapatalk

 

[MacTechVpr]

VHO Raiju like the Helios, a solid block dual pos head. But your issue could be 510/pin length. And the adjustment on the CANA isn't very good. Had to play with it some for one RDA. Make sure the RDA fires on something else then adjust the 510 with confidence. It should fire.

Good luck!



p.s. It occurs to me that your chipset may be different than what I have on mine although it appears we may have gotten it around the same time. No way of tellin' don't think with FT. I was kind of surprised that it did as I've noted similar remarks. I missed you've tried several things on it but it still could be the pin.

 

[MacTechVpr]

Protank MicroCoil Discussion!!

Tensioned Micro Coils. The next step.

 

[jlwiseman]

Don't waste your money. The Bluetooth never worked unless I held it against my phone, it barely put out the 50w when the battery was fully charged, the firing button rattled, and it damaged a Samsung 25r battery.

 

[MacTechVpr]

Don't waste your money. The Bluetooth never worked unless I held it against my phone, it barely put out the 50w when the battery was fully charged, the firing button rattled, and it damaged a Samsung 25r battery.

Sorry to hear of your bad experience with it jl.

Enjoying mine quite nicely with a variety of builds just below and above .8Ω both spaced and contact tension winds. Worked the high end impressively with the Subtank up to 45W but I didn't wish to push the tank any further. Dropped a Raiju on it with a .3Ω build and very decent production at that power level. No problems either with any batt's tested (VTC4 SONY, MNKE and a few Subohmcells. Although I though I'd blown it inverting the battery on first install (it takes it upside down unlike most). There my big complaint about this device that it does not designate +/- orientation. Didn't see where it was documented either.

Mine obtained from Madvapes fared similarly well to two others I've sampled with friends. Smoothest performance of the four variables I own including an authentic ZNA30.

Haven't tested the Bt. No interest, or hope, of anything being able to keep tab of my puff counts.

But you're absolutely right about the noisy button. Wish it were dampened...I like the clicky tho.



Good luck.

 

[k0shi]

I just sent my bt50 back to mad Vapes today to have them do the update


Sent from my iPhone using Tapatalk

 

[MacTechVpr]

I just sent my bt50 back to mad Vapes today to have them do the update


Sent from my iPhone using Tapatalk

What's that about? Any news?

Good luck.

 

[k0shi]

What's that about? Any news?

Good luck.

So I sent it out and received it back because I payed for first class shipping but put it in a priority box lol I should be sending it back out for the update today.


Sent from my iPhone using Tapatalk

 

[MacTechVpr]

So I sent it out and received it back because I payed for first class shipping but put it in a priority box lol I should be sending it back out for the update today.


Sent from my iPhone using Tapatalk

LOL. Sorry to hear that.

No, I was wondering what the Madvapes update thing was all about. I know about the Bluetooth app. Just haven't had time to look into that.

Good luck.

 

[k0shi]

LOL. Sorry to hear that.

No, I was wondering what the Madvapes update thing was all about. I know about the Bluetooth app. Just haven't had time to look into that.

Good luck.

Just a update for everyone I just received my bt50 back today from mad Vapes and I have to say it's a lot better after this 65watt update and yes I did pick up a istick 50 as well. All the problems I had with my bt50 previously is no longer there. Fires straight away off the sleep screen and doesn't go to sleep so quick any more

Sent from my iPhone using Tapatalk


Sent from my iPhone using Tapatalk

 

[MacTechVpr]

Just a update for everyone I just received my bt50 back today from mad Vapes and I have to say it's a lot better after this 65watt update and yes I did pick up a istick 50 as well. All the problems I had with my bt50 previously is no longer there. Fires straight away off the sleep screen and doesn't go to sleep so quick any more

Sent from my iPhone using Tapatalk


Sent from my iPhone using Tapatalk

Very cool. Now how do we get it?

Good luck.

 

[k0shi]

Very cool. Now how do we get it?

Good luck.

Just contact mad Vapes all you pay is shipping and they do the update for you, mine wasn't even purchased through them.


Sent from my iPhone using Tapatalk