SPECIFIC CARTOMIZER for the KR808D-1 HELP PLEASE

[wefishallday]

While I can find many "blank" cartomizers from different vendors that "fit" the KR808D-1 battery, I can't seem to locate one yet that has all these features:

1. DOES HAVE the small inner silicon seal under the cap

2. DOES HAVE the little notch in the cartomizer on the battery end (not flat)

3. Ohms of ~3.0

4. Don't care that much if it's slightly longer or shorter

5. Really don't care if its a verticle or horizontal coil.

6. DON'T CARE if it's hard or soft cap -- just not glued on.

I've recently ordered a 5pack of "Kangers" from a vendor (in USA) for the KR808D-1 which were "advertised" on their website as having the inner seal, BUT they don't have an innerseal - only the hard cap. Said they don't know the Ohms as Kanger didn't rely to question. Does have the notch on the carto.

This vendor also send me one cartomizer sample of the Boge for comparison which the vender also sells (and they said did NOT have the inner seal). It was "individually" wrapped, is definitely a verticle coil, has a softcap and NO inner seal. Ohms were 2.8. Does have the notch on the carto though.

Prefer not to state the vendor here. Yes -- will advise them that the Kanger cartos they are advertising with the inner seal don't actually have them.

Does anyone know of a vendor who DOES sell a blank KR808D-1 cartomizer that meets my specs above? (inner seal, ~ 3 ohms, notch in carto at battery end - cap not glued on.)

Thanks so much
Note - I do know where to get these prefilled with juice -- but I am looking for blanks.

 

[Kurt]

These may fill you needs:

KR808d-1 Cartomizer : Cartridge Atomizer | Cigarette Cartridge Pack | Blank Cartomizer | Cigarette Cartridges

My experience with kr808d-1 cartos is less than for 510 cartos, but I did buy some of these when I was using a kr808d-1 PV. I did have a couple that had the flat, no-notch, threaded end, but I think those were production mistakes, as all the rest had the notches. I would talk to this vendor to make sure though. They were ~3.1 ohms. Not sure of the inner seal ring, but I seem to recall one being present. These are good cartos, with improved filler compared to kanger.