I would say it is normal, never heard a transformer run that didn't buzz a little. Unless it didn't have power to it.
Last edited:
As long as it works better then my rDNA40, which has become another VW mod for me, I'll be happy. I have a lot of nickel wire to be used.
QUESTION for the lemo 2 users.
I have one being delivered tomorrow... 26g or 28g ni200?
I used 30 in mine, as that is all i have on me at work. But i like 28 usually.
I'm sitting here debating the attempt at a dual coil in my Infinite Magma clone now.
Might be a dumb question, but what do you use to block off the other air hole anyway? If i did decide to give the single coil a try that is.
Phil should have someone else listen while he fires it without a wick. I didn't think mine made any sounds initially until I had my kids listen while I did a dry burn at .23Ω and they could hear it right away but I still couldn't.
1 joule =1 watt/sec
20j over 10 seconds = 2watts per second
I don't agree but I don't want to discuss it either. Joules has embedded time so the op got it right.Almost right ... you got turned upside down .... Joules is energy, Watts is energy over a period of time....
1 Watt = 1 joule/second
20 joules/10 seconds = 2 joules/second = 2 Watts...
On another note, picked up an SX Mini M on Wednesday. N200 on order. Loving it so far.
Great thread, I have a lot of reading to do over the weekend....
The P3 wasn't cutting it for me with 26 ga and I wanted/needed something a bit more powerful.. My mini vaporshark (DNA 30) was ok but left something to be desired with build quality and battery life. IMO, so far, this is the box version of the P3 that we hoped the P3 would be.. and then some...Glad I waited for it.
Atlantis Mega is 5 ml. I hear ya about the expense, but until Vaporshark's exclusive access ends, it's the only choice we have for pre-made coils on the Kanger and Aspire tanks. I guess I've been spoiled by Fasttech when it comes to cheap replacement coils.
Phil should have someone else listen while he fires it without a wick. I didn't think mine made any sounds initially until I had my kids listen while I did a dry burn at .23Ω and they could hear it right away but I still couldn't.
I hear it even with a wick. He should just have someone else listen in general because maybe he just can't hear it himself.
Almost right ... you got turned upside down .... Joules is energy, Watts is energy over a period of time....
1 Watt = 1 joule/second
20 joules/10 seconds = 2 joules/second = 2 Watts...
.
I personally can't hear it unless I put the case of the device right ON my ear. Not close to or next to, I mean RIGHT ON my ear, allowing the vibrations and sounds transfer directly from the case to my old man eardrums.
Sent from my iPhone using Tapatalk
Question: do you need to install the driver and 1st upgrade firmware if you just bought the mod?
Question: do you need to install the driver and 1st upgrade firmware if you just bought the mod?
Question: do you need to install the driver and 1st upgrade firmware if you just bought the mod?
I have my arms stretched out as far as I can put them in front of me and I hear it.