And I wouldn't worry about a bit of juice getting inside the battery wrap, as long as there's no physical damage to the wrap. It's not going to do any harm.
- Status
Like has been mentioned a q tip & rubbing alcohol if you have it, or a pencil with an eraser on the end.
Wipe back & forth & twist the eraser until the contact is shiny, then turn right side up & blow residue out.
Wipe back & forth & twist the eraser until the contact is shiny, then turn right side up & blow residue out.
A paint brush can be used to get in nooks and crannies, but be careful with Isopropyl Alcohol. It has a habit of dissolving certain plastics.
It can be mixed 7 parts IPA to 3 parts Distilled Water, this stops it from dissolving plastics.
It can be mixed 7 parts IPA to 3 parts Distilled Water, this stops it from dissolving plastics.
If you are talking about the 510 connection, I just twist up a dry paper towel and press it into the 510 and twist. Everything comes clean and shiny with a few turns. It cleans the threads as well as the center contact. As Topwater Elvis said, just blow out any traces of paper fibers after that.
Alcohol won't hurt it, just use a paper towel wetted with alcohol if the dry towel method doesn't get it off.
Last edited:
I also have my first external batteries mod, and questions. I've watched a lot of videos but I'm not clear on certain points.
I'm getting my second Voopoo Drag today or tomorrow. The first one was killed, I think by someone trying to charge it via its mini USB, while I had the batteries in my room, charging one after the other in a one battery charger.
Would that have killed it? And is it bad for me to charge one battery at a time? Thank you.
Sent from my Nokia 6.1 using Tapatalk
I'm getting my second Voopoo Drag today or tomorrow. The first one was killed, I think by someone trying to charge it via its mini USB, while I had the batteries in my room, charging one after the other in a one battery charger.
Would that have killed it? And is it bad for me to charge one battery at a time? Thank you.
Sent from my Nokia 6.1 using Tapatalk
Yes this might killed the board.
It is suggested to use properly paired batteries
Same Brand
Same size
Same chemistry
Same Mah rating
Same Charge
Same CDR
Same age
and charge/discharge always together!
Ok, thanks. Until I get a 2 battery charger I'll hope it's ok to charge the 2 batteries in the unit. At least they'll be together.
Sent from my Nokia 6.1 using Tapatalk
- Status
Similar threads
- Locked
