this is going to sound like the most newbie question ever........
How do you check all the stats of volts and the other info when you are actually using the darwin? Or do you just push the button and look? How long do you hold down the button for?
I have worried that it is bad to do that while not pulling. is that not the case?
I am generally getting this 3.4v 2.3a 1.4om. what do these numbers mean and how do they relate to what I have it set at?
You can check the stats by holding the button for a few seconds. As long as you don't do it for too long it will be fine. Seems like you are using a low resistance atty/carto so you probably don't wanna crank it up too high. I would run it under 4v to be safe


