the duke wood mod project

Status
Not open for further replies.

carlph

Senior Member
ECF Veteran
Verified Member
Nov 22, 2013
114
81
sweden
Hi i built my self a DNA20 mod that work really well and i guess i had to much fun because now i would like to build a "clone" of the duke but in wood instead.

Do anyone have a partslist of what i need to buy ? =)

my DNA20
2y2e5yhy.jpg
 

dropsomegears

Full Member
Oct 26, 2012
17
2
Raleigh, NC
1x OKR-T10 regulator
2x 16v 10uf tantalum capacitors
1x 220ohm resistor
1x 15kohm resistor
1x 200ohm potentiometer
1x Push button of your choice
1x 2x18650 battery holder
1x 510 mod connector

You can get most of the stuff from digikey, except the 510 connector.

Part numbers would have made you my hero. =) but thanks. Isn't there a suggested amp to have with a switch ie 3amp-10amp switch??

Sent from my SCH-I605 using Tapatalk
 

Laoboi

Senior Member
Verified Member
Jul 1, 2013
73
15
Nashville
Yeah, at least a 3amp switch would be fine. But I've read that is it is any lower than 3amps then you can use pin1 on the OKR-T10 chip to use a lower rated switch as Mamu stated in a thread on breakthru.
A reason for using pin1 is to be able to use a non rated fire switch (pin1 is inline with an internal MOSFET which takes the load off the switch). If you're using a 3A switch then pin1 is not needed. If you're wanting to use a tactile switch, then you will need to use pin1.
 

Laoboi

Senior Member
Verified Member
Jul 1, 2013
73
15
Nashville
I'm building a dual 18650 DNA30 in the same time will the Hammond 1590B or 1590G be the best choice? could i use the same box for a duke to?

The 1590B works good for a DNA mod and the 1590G is best for the Duke. You can fit a DNA mod with 2 18650 in a 1590G, but you have to modify the enclosure a bit. It is a really tight fit, but it is possible. I am in the process of doing so.
 
The 1590B works good for a DNA mod and the 1590G is best for the Duke. You can fit a DNA mod with 2 18650 in a 1590G, but you have to modify the enclosure a bit. It is a really tight fit, but it is possible. I am in the process of doing so.

Laoboi do you have a pics posted of the 1590G with two 18650's I keep looking at the box and trying to figure out how I can get it all in there.
 
Status
Not open for further replies.

Users who are viewing this thread