Had a little free time so i built a cool and unique voltage indicator extender "The GlowStick" . It screws into a 510 battery and has another batt connector at the other end to screw in a atty/carto . It is like the ones madvapes sells but half the size box wise and much cooler imo .
Parts used :
-Small potting electronics box (Ebay) Note: Must desolder the pin array off the indicator to fit it in this box
-1 fluxomizer clear tube (gotvapes)
- Atomizer connector ( can get off of a atty or buy it from madvapes)
- Sealed 510 batt connector
- 1S voltage indicator
- Small pcb (I used a piece of copper clad i had laying around .It was already etched with a circuit design my company makes for smd LEDs )
- 2 Blue side emitting Plcc2 smd LEDs (3mm LEds should fit also)
- 2 150 ohm resistor (This will change depending on what LEDs are used .Make sure the LEDs are resistored for the highest voltage you will use it on )
- Electronics potting compound ( can use epoxy or silicone as well .Used to fill the box flush and mount the tubes)
- Carbon fiber dinoc ( you can sand and paint if you want as well )
The batt and atty connectors fit perfect inside the fluxomizer tube . I gotta say i love how this little project came out. Heres the pics .
Parts used :
-Small potting electronics box (Ebay) Note: Must desolder the pin array off the indicator to fit it in this box
-1 fluxomizer clear tube (gotvapes)
- Atomizer connector ( can get off of a atty or buy it from madvapes)
- Sealed 510 batt connector
- 1S voltage indicator
- Small pcb (I used a piece of copper clad i had laying around .It was already etched with a circuit design my company makes for smd LEDs )
- 2 Blue side emitting Plcc2 smd LEDs (3mm LEds should fit also)
- 2 150 ohm resistor (This will change depending on what LEDs are used .Make sure the LEDs are resistored for the highest voltage you will use it on )
- Electronics potting compound ( can use epoxy or silicone as well .Used to fill the box flush and mount the tubes)
- Carbon fiber dinoc ( you can sand and paint if you want as well )
The batt and atty connectors fit perfect inside the fluxomizer tube . I gotta say i love how this little project came out. Heres the pics .









Last edited: