Status
Not open for further replies.

clyde2801

Vaping Master
ECF Veteran
Verified Member
Dec 13, 2009
4,039
3,173
In the land of no hills and red dirt
This will be the end of all worries for users that have rebuildable atties in a tube mod. :D

the 5-10W range is perfect for me, i'm a 7-8W kind of guy.
:toast:


You mean like THIS?!?

Just makin' sure....


Purdy, ain't it?

You can't tell from the picture, but my bulli has been precisely kicked. Beautiful part if it really don't frakkin matter how many ohms I get from my semi blind coil winding. I think VW is a must have for any rebuildable mod.
 

Attachments

  • Photo on 2-15-12 at 3.56 PM.jpg
    Photo on 2-15-12 at 3.56 PM.jpg
    22.4 KB · Views: 109
Last edited:

vapn

Vaping Master
ECF Veteran
Jul 10, 2009
3,457
525
UK
You mean like THIS?!?

Just makin' sure....


Purdy, ain't it?

You can't tell from the picture, but my bulli has been precisely kicked. Beautiful part if it really don't frakkin matter how many ohms I get from my semi blind coil winding. I think VW is a must have for any rebuildable mod.

What model is your bulli Clyde?
 

clyde2801

Vaping Master
ECF Veteran
Verified Member
Dec 13, 2009
4,039
3,173
In the land of no hills and red dirt
That looks like A2-TM with Ego B drip tip, modded for dripping?

Damn, you're good! Stainless steel. It's stock configuration, with the soft tip from a dual coil mega ego carto. I've found a dropper bottle top (similar to what you'd use to put a drop or two of say, eye medication in your eye) is perfect for putting a quick drop right on the spike.
 

BuzzKilla

Ultra Member
ECF Veteran
Verified Member
Nov 4, 2010
2,036
2,152
Etobicoke, Ontario
www.graindeep.etsy.com
^^^^^^^^^^^^^^^^^^^^^^^
I think a kit with washers and battery pre-setup is a bit overkill. Figuring out washer / o-ring combination is super easy. the P+ comes with more than enough of both for a variety of setups...

Clyde
The Kick is the George Foreman of vaping,
*meant to say Showtime Rotisserie by Ron Popeil, got my Infomercials mixed up...*

SAY IT WITH ME!
"Set it, and forget it!"
 
Last edited:

ridenit

Senior Member
ECF Veteran
Verified Member
Nov 24, 2010
76
50
Texas, Dallas
I would wait to buy a P+ with the kick if this can happen as a kit.

I think the only problem with waiting is the Kick may ramp up sales on the precise line and you might run into a problem even finding one for a while after launch. IMO, I'd buy the PV and then a kick separate since this will most likely be how it will be for a while until the orders start to slow down. This is purely speculation. I love my 18500 and can't wait for the Kick. But I wouldn't want to have to wait for a kit either. Best of luck to everyone.

Sent from my MB860 using Tapatalk
 

clyde2801

Vaping Master
ECF Veteran
Verified Member
Dec 13, 2009
4,039
3,173
In the land of no hills and red dirt
^^^^^^^^^^^^^^^^^^^^^^^
I think a kit with washers and battery pre-setup is a bit overkill. Figuring out washer / o-ring combination is super easy. the P+ comes with more than enough of both for a variety of setups...

Clyde
The Kick is the George Foreman of vaping,

SAY IT WITH ME!
"Set it, and forget it!"

Hear what yer sayin...

but my Kicked Plus is sexy. Tha grill ain't.
 
Status
Not open for further replies.

Users who are viewing this thread