Hi Drew,
Just wanted to report back here.
(Wall of text warning, my apologies in advance)
I've had issues with leaking. I watched the video you have on YouTube over and over. Clean everything out, and followed the video to the T. I probably have every word you say memorized.
I've tried to get the sucker to work with me. I can say when it's not leaking, it's amazing - the hits are very nice. But the leaking... It leaks out of the very bottom of the atomizer, almost like it gets flooded. It's pretty consistent leaking too; I've lost a lot of juice in the past week.
I've tried different PG/VG amounts (as much as 50/50, and 70/30), and no go. The O-Rings seem to be fine, and I use a Slap-Yo-Mama adapter when putting the atty in the tank. I've also used the ends that come with the atomizers.
Within about 5 minutes, I can guarantee once I screw the atty off my device, there's a nice puddle starting to build up, and a nice pool at the very bottom of the atty connector.
Any suggestions, please? At this point I'm starting to get frustrated
Edit: Just want to add out of the 3 atties I have, one of the 2.5 Ohm seem to not cause as much leaking, which leads me to believe that its possibly an atty issue? I placed a second order this past week for a single atty, the 1.5, and that seems to leak the most. It also looks like the hole is a little malformed. It's larger than the holes on the other atties, and kinda goes "up" and isn't really a "perfect" circle (in comparison to the one that leaks very little, if at all), so that has to be part of the reason that one leaks so bad.
Could it all be the fact that I have a couple dud atties?
I would love to one day do a video review, but would prefer to hopefully remedy the problems I'm having before I do so; that way I can give the system the justice (that it definitely seems like) it deserves.
Also, just want to thank you guys again for the rockin' customer service you guys gave me last week.