Morning everyone. Well I did it! I built my first micro coil on my new RM2! First attempt it metered at .81 using 28g wire. Put it on my VV and would not fire. Well played around with it and adjusted and think I did not have one post screw tight. Got it wicked with rolled cotton and vaped great for first couple hits then I burnt the cotton! Figures! Re wicked and working fine now. I just have to get used to this squonking with it. I always used shorty cartos and you could see the juice start to come up into the well. With the RM2 you can not see the well because of the size. Is there a general rule of thumb??? Like three hits then squonk???? I think I was spoiled with the easy and convience of just slapping on the shorty cartos. This will be a learning curve for me. Guess I will have to carry around some cotton with me at all times!
I agree with the previous poster of 1-4 hits per squonk. You can also use silicon wick. People use the 1mm wick doubled with ease. I am currently trying it myself. Once you make the coil, you can take a wire doubled through the coil, and take the silicon and put it in the doubled wire to pull the doubled wick through the coil. I would recommend that you test that out as well. You might like it as well as cotton and not have to wick as often. If you continue to use the cotton, just remember that you cannot over squonk. Anything is better than a dry hit on cotton wick.
