Hey all,
Since this will be my first bottom feeder, I have some Q's. I've been using DC carto's since about June, but before that was a solid dripper. As much as I like the convenience of carto's, I would much rather experience the "drip-vape" with a 9 mil supply bottle. Is this what I should expect using an atty on the Vapage , or is it somehow different?
I'll honestly prefer atties because I can clean and reuse them, whereas my cleaned carto's just feel clogged and weak.
good point...
this is an easy bottom feeder to learn on imo.
The trick with bf, like dripping, is to get the right amount of juice in the atty; not too much, or too little.
I think the best way to gauge the juice amount is to take the XL cone and collar and atty off, tilt it and watch how much juice comes out as you squeeze. Get a feel for how much pressure you use to squeeze so it becomes consistent.
That way you "know" how much juice is going into the atty.
With the XL system, you can always blow into the d/t to get excessive juice out of the atty; it will go back to the bottle.
fwiw; a SR atomizer (2.2 to 2.5 Ohm aprox) needs less juice than an LR 1.5 Ohm... gotta keep those LR's wet.
I'm using a i06 LR 1.5... fabulous vapor, and with the IMR AW 18650 = wow
, dont do it to hard or you will blow juice out the hole
I've simply been using the tilt and vape method, and it's working flawlessly, perfectly fed atty at all times
Here's the thing, the adapter from IKV is sealed, so it won't feed(that's the one I use on ALL my 510 devices
