Tootle Puffers, Part Three! (The Sequel of the Redux)
- Thread starter Katdarling
- Start date
- th_trl_thread_readers 0
Much easier and better to replace the rba instead of the base. imo
Costs less too.
Agreed [emoji4] this one is about to go in the trash. Just going to try a new coil one more time
Sent from my iPhone using Tapatalk
jus cuz:
did you just take the RBA apart to have a look ?
maybe just disassembly then putting it back together will result in a fix
(shot-in-dark)
did you just take the RBA apart to have a look ?
maybe just disassembly then putting it back together will result in a fix
(shot-in-dark)
Does the rba work in any other base?
Good idea, Puf. May actually work. I ran STMs for a while, and found that some of the RBAs needed to be REALLY tight in the base to make contact. A full dis- and re- assembly may work.
+3
+ 1 . . .
+3
It appears only the screws come off but I'll definitely keep them!
Sent from my iPhone using Tapatalk
Didja buy it from fastech or a similar site?
This the one that came with the set. It was from MFS
Sent from my iPhone using Tapatalk
Authentic's come apart like Puffs picture, some clowns do some don't.
* clones * not clowns, dangit
Try backing the 510 pin out just a tad. Use a coil mandrel (small screwdriver) through the air holes. (For full tear down, you'd take it all the way out - the positive post will then fall off )
Make sure the pos post is still firmly seated, don't want it wiggling around! (And in your previous pic, looks like a small tail off the coil is sticking out past the base - will probably be a short when the chamber is put back on. Also, you want your coil leads coming in on the LEFT side of the screw, so tightening the screw draws the wire in tighter instead of tryig to push it out. Hence the left/right, clockwise/counter coil winding )
)Make sure the pos post is still firmly seated, don't want it wiggling around! (And in your previous pic, looks like a small tail off the coil is sticking out past the base - will probably be a short when the chamber is put back on. Also, you want your coil leads coming in on the LEFT side of the screw, so tightening the screw draws the wire in tighter instead of tryig to push it out. Hence the left/right, clockwise/counter coil winding
)
jus cuz:
did you just take the RBA apart to have a look ?
maybe just disassembly then putting it back together will result in a fix
View attachment 652141
I tried with pliers to remove the post and bottom pin but they didn't budge
Sent from my iPhone using Tapatalk
cool, try holding the top flange , then something like lil screwdriver thru bottom holes to 'twist' hollow screw out...
the arrows is where this example broke...
cool, try holding the top flange , then something like lil screwdriver thru bottom holes to 'twist' hollow screw out...
View attachment 652157
View attachment 652159
the arrows is where this example broke...
I didn't realize the bottom unscrewed, I just got it off! First victory for getting more parts!
Sent from my iPhone using Tapatalk
Similar threads
- Locked
