That explains a lot!
I can't get the scent of this H One Y One out of what I suppose must be the o-rings. Powerful scent.
UD AGI - my first ever build. Have some questions.
- Thread starter Born2Hula
- Start date
- th_trl_thread_readers 0
- Status
That explains a lot!
I can't get the scent of this H One Y One out of what I suppose must be the o-rings. Powerful scent.
91% or higher Isopropyl alcohol will kill the odor of skunk spray on a atty
hahaha!! I had run out of vodka and wasn't sure it was safe to use the isopropyl or not.
I had asked a Dr. friend about Iso. He says it's fine. Just make sure it's evaporated.hahaha!! I had run out of vodka and wasn't sure it was safe to use the isopropyl or not.
I take it popping in the dripper is normal?
(thanks for not being bothered by all these noobie questions)
(thanks for not being bothered by all these noobie questions)
Yes, that's just a little air in between the coil and the wick popping. I strongly believe that adds more flavor.
Your'e welcome. I love helping
Is the reason I'm not getting massive plumes (like you have coming out your nose) because I am running at 1.2 ohm and not sub ohm or is it more a factor of PG/VG? I'm currently using a 65/35 ratio.
Sub ohm requires a ton of airflow. That pic is used with a dual coil at .4 ohm 50/50 pg vg at 6 mg.
No not noticeable.
Yes, I'd get some time in before playing with sub ohm. I researched it for a couple of months before I took the plunge.
Last edited:
And even if you DO go sub-ohm, it's best to err on the side of paranoia.
That pretty much sums up how I feel about it currently. I do not wish to misstep. I know everyone's doing it, but at present it's quite a stretch for me.
I remember when I first started vaping. I used Ego atomizers. I used them so long the resistance was shot. The coil would just glow no matter how much juice was on it.
I remember when I first started vaping. I used Ego atomizers. I used them so long the resistance was shot. The coil would just glow no matter how much juice was on it.
Do you mean these things? (let the page fully load)
https://www.google.com/search?q=aga-t3&tbm=isch&tbo=u&source=univ&sa=X&ei=Pk-SUqn6EonskQf9wIGYDw&sqi=2&ved=0CCwQsAQ&biw=1701&bih=869#q=ego+atomizer&tbm=isch&facrc=0%3Bego%20t%20atomizer&imgdii=_&imgrc=_
I'm guessing you've been at this a while Any recommendations for my next step in RDA's? My goal at the moment is either the Kayfun or the R91.
Any recommendations for my next step in RDA's? My goal at the moment is either the Kayfun or the R91.
One thing I can say, the deck of this ADI is very small. The holes for insertion are very small too. Not sure if that's more refine as you step up or not. Drilled holes in the posts that are conspicuously missing on this model would be very helpful also.
I just received a Kayfun 3.1 clone from Fast Tech last week. It's a long wait but for 20 bucks it's an exact copy.I'm guessing you've been at this a while
- Status
Similar threads
- Locked
