Oooh! Power off, and then press and hold the fire and up buttons at the same time for 5 seconds. As a side note, holding the fire and down buttons when powered off will show the current battery voltage.
Vape Forward Stout thread
- Thread starter Marc411
- Start date
- th_trl_thread_readers 0
- Status
Has anyone noticed the screen is pretty dim? When comparing it to my RX200 the screen on the Stout has an amber tint to it and the text doesn't seem as clear.
Yes! If I have one complaint, it's how dim the screen is in daylight. Hopefully this can be fixed in a firmware update. Might be worth an email to Wismec inquiring about such.
They're techs, they never get to see the light of day
At least they could put a Asterisk next to the work "OLED". Like this OLED* Display.
* Note: Screen Can Not Be Read in Direct Sunlight. Only Use Indoors.
I am on the fence with this one. I want a 26650 mod and can't decide between this and the Sigelei 90 Watt Plus... The Sigelei has a sleeve, comes with a tank, and some coils but doesn't do SS TC This one goes to 100 watts and is upgrade able but no sleeve. Also there isn't a 26650 that can push anything past 20 amps to get to that output safely.
This one goes to 100 watts and is upgrade able but no sleeve. Also there isn't a 26650 that can push anything past 20 amps to get to that output safely.
Frickin' battery is lasting forever! Two full days, 10+ mls of juice at 27.5 watts on a .7 ohm coil and the battery looks to be at the 75% mark. I swear I found a way to show the actually voltage of the battery remaining by pushing a random combo of the buttons but I have not been able to do it again. I was trying to figure of how to get it in wattage mode before looking at the manual.
BTW, I'm using a Brillipower 4500mah battery. It's the same one that's pictured with the Stout on the VF site. I'm not a big fan of the Brillipower brand but I know that I am barely pushing the battery and my MKNE battery is still in transit.
BTW, I'm using a Brillipower 4500mah battery. It's the same one that's pictured with the Stout on the VF site. I'm not a big fan of the Brillipower brand but I know that I am barely pushing the battery and my MKNE battery is still in transit.
While powered off, fire button+down for 5 secs or so will show you the voltage of the battery. MNKE Orange lasts a good while as well.
I love Sigs but I refuse to buy another one until they start offering upgrade capabilitie. Great mods but they need to step it up in that department.I am on the fence with this one. I want a 26650 mod and can't decide between this and the Sigelei 90 Watt Plus... The Sigelei has a sleeve, comes with a tank, and some coils but doesn't do SS TC
Sent from my SAMSUNG-SM-N915A using Tapatalk
The finish is OK and what would be expected for a sub $100.00 mod. I have a feeling the silver one will be the best finish given the material it is made of. I like my black stout do much I will get a silver one for sure.
Is the quality like the OG Vapor Flask? Hell no, but it is significantly less cost too.
Is the quality like the OG Vapor Flask? Hell no, but it is significantly less cost too.
Finish on my Black is holding up well so far but only time will tell.
The Silver & White is in stock at VF.
Vape Forward
Silver on the way
The Silver & White is in stock at VF.
Vape Forward
Silver on the way
Last edited:
I just ordered 3 Joyetech Cuboids 
what battery brands are known to work in the Stout besides the Brillpower? a lot of 26650's are 67mm in length and are to long? from what I can tell you need a 65mm battery... one of the only ones I can find is the 4000mah Efest @ 65.11mm. I would hate to order batts and have them not fit
The MNKE IMR 26650 is what I'm running in mine. They are a little tight but work well.
MNKE IMR 26650
MNKE IMR 26650
- Status
Similar threads
