Vapourizer Cleanser??

[gryffandor]

I'm not sure what I'm doing differently from anyone else but the OK Cleaner works great for me. I used it in an 801 & a 901 that were vaping about 25% of normal & they both are like new after 1 treatment. For the 901 I dripped 10 drops in the battery end, cleared out per instructions after 5 mins & used another 10 drops. Cleaned out after another 10 mins & left to dry 2 hours. Primed & puffed away like new. Tasted like factory prime for about 5 puffs, then fine.

For the 801 I used 12, then 30 drops & got the same result.
I seem to be detecting quite a bit of paranoia on some of the posts concerning saftey. I got some of this on my fingers & left it for quite awhile so I don't think there is much if any acid. It does smell somewhat like acetone when first used but the smell quickly disapeares. I dripped some on a tissue & after a hour it could not be detected, no smell or mark.

I don't think anyone can be sure whats in the e-juice thay vape all day long so I'm not sure about all the concern with this cleaner. I'm still around after using it with no ill effects so I don't have any problems continuing as long as it keeps working.
It will not bring back a totally dead atom. so don't expect miracles. It does improve the quality of a cloging one to new state & is worth the cost to me. YMMV

 

[Gemini]

I have also used the oksmokey cleanser on 4 dse901 atomisers that were going downhill, producing barely any vapour. I followed the instructions and they were all as good as new. I put 10 drops into the battery end and left it for 3 minutes, shook it out, repeated, then left to dry off for a couple of hours, dripped 3 drops of eliquid onto the bridge and it vaped as good as new.Just before using it again i couldn't smell anything, and in use i could just about taste it for a few draws, bit like factory primer. All in all. i will definitely keep on using the cleanser, i would have thrown the 4 atomisers away, but nearly 3 weeks later and they are still going strong, and so am i.

 

[Fud]

I'm not an expert but once a week I just dump the attys in rubbing alchol in a shot glass and let it sit for about 6 8 hours and rinse them out good after. Then using a hair dryer aim it on both sides and let dry over night, then the blow dryer again just to be sure. So far the coils still look shiny and new. Unlike that pic someone posted with all that black crud on it. That old charred stuff must taste like kaka.

 

[bobnot_]

all this atomiser cleaning malarky fascinates me i never clean mine i only use RN4081 atomisers now as they are far more robust than any other kind ive tried (ive tried most but then sold them as they never seem to match the RN4081) i occasionally put my atty on my passthrough and hold the button down until it glows bright orange for at least 10 seconds and burns off anything left inside.

some people say they clean them every day! 8-o why????
im convinced people that clean them hasten the demise of all their atomisers.

the atomiser im currently using all day every day is over 2 months old and working as well as it always has done i have bought 7 atomisers since i started vaping at the start of october 09 and i still have 2 unused i just dont get how people kill so many!

i strongly suspect its boiling them!