What percentage are Vaping at Provari Levels

[niczgreat]

Hi Recently I said that 70% to 90% are vaping within the tolerances of a Provari
I'm going to make this poll simple.

Not sure
Plug in the resistance of your Atomizer [Ohms] and the Volts that you are vaping at and if it's below
3.5 Amps then answer Yes.
Ohm's Law Calculator

If you are vaping a Provari then Answer Yes
If you are vaping a Ego or Ego Style then you will Answer Yes.
If you are vaping on a Itaste MVP then Yes
If you are vaping above 1 Ohm and plug into chart and find you are below 3.5 Amps then answer yes.
If you are vaping above 6V then you will answer no
If you are vaping on a bottom feeder and using a stick atomizer [Prebuilt] Definitely Yes
If you are vaping on a bottom feeder and using a RBA Above 1ohm [Borderline Either Way is Fine]
If you are on a Mechanical but you are vaping at above 1 Ohm and below 3.5 Amps then answer Yes

 

[BernieVideo]

What if you are bottom feeding on a Provari?

It is possible ya know.

 

[niczgreat]

What if you are bottom feeding on a Provari?

It is possible ya know.

You are correct there is a device called a surge tank and another device that allows bottom feeding on a Provari. If you are using such a device then by all means Mark Yes.

 

[Plumes.91]

Why would people using bottom feeders say NO?

 

[niczgreat]

A individual who is vaping on a Bottom Feeder is using a device in a different Arena.

The purpose of the poll is to see mainstream vaping and who would be happy on a Provari. Bottom Feeding is on the Fringe.
I may be biased but I'm a bottom feeder and the only time I'd use a non bottom feeder is as a back up or for
special use, like a MVP on a camping trip.

Bottom Feeding isn't Mainstream yet.

 

[Plumes.91]

Okay. Reos came out before tanks not after. I mean, Reos are fantastic but there's not much logic in separating vapers that use bottom feeding mods from people that use regular mechanical mods with dripping atomizers on top. The only difference is the direction the juice comes from and the convenience.

Also everyone should test their amp draw at the same battery drain level. Freshly off the charger. The results could be all over the chart if they didn't use the same battery voltage. If people are vaping with a fresh battery off the charger (4.2 volts) on a full mechanical mod, then with a 1.3+ ohm coil they are going to be vaping within the Provari's amp limit. Anything under is under the Provari's amp limit.

Depending on what demographic this poll would appeal to, your results will be skewed that way as well. Typically people that vape an MVP aren't going to know and aren't going to care if they are vaping within provari's amperage limit so they probably wont find the thread title interesting enough to click on it. Or less would.

But yeah. If your using a mech with a fresh battery at or above 1.3ohms, your within provari's range. Although you may need to use a lower voltage on the provari with a 1.3 head so any mechanical would beat this until the battery drained a bit. This is where the provari shines because it can keep the voltage at a constant until the battery is dead.

 

[DC2]

My answer is yes because I vape an Ego Twist at 4.8 volts with a 2.3 ohm 510 atomizer.
And I really don't think that bottom feeders are "fringe" devices.

 

[EvilZoe]

I don't like this poll because I use all of the above...lol