Wire Popping...?

Status
Not open for further replies.

krnxguhj33

Super Member
ECF Veteran
Verified Member
Nov 8, 2011
676
391
35
Victorville, CA
Sorry, I kind of woke up from a nap when my coil popped.

Info:

- 3.7v battery (AW IMR 18350)
- Coil ohm ~1.5 (Don't have a multimeter but it was 2.5 cm of stock resistance wire)

I had two full wraps around 2 pieces of wick (I use the method shown by Scott). I was on my second tank when it popped and the vapor production was nearly nil.

However, I think that the coil was slightly looser than usual because I had to make a coil in a hurry and I kind of haphazardly made one.

I think your advice is spot on Poppa D because the new one I made is tighter and it hits better than the one that just popped.

Thank you!
 

Killjoy1

Ω Destroyer
ECF Veteran
Verified Member
Aug 15, 2011
9,304
9,365
46
New Hampshire, US
I had that happen once during a dry burn, I actually saw the little flash when it went. Make sure your twists are nice and tight and that your twisted parts aren't sticking up too far away from the wick, if that joint is weak and away from the juice where it stays dry then it can get hot enough to pop the joint between the wires. That's my theory, anyway
 
Status
Not open for further replies.

Users who are viewing this thread