WISMEC Reuleaux RX200 TC

Status
Not open for further replies.

druckle

Ultra Member
ECF Veteran
Verified Member
Sep 20, 2013
1,149
2,193
Scottsdale, Arizona, USA
Dern tootin pal. It's an excellent choice for folks like me who taste very subtle notes far too much. Even wiping the Ti wire with 91% isopropyl left me with a foul after-taste so I use it for that as well now. I find a solution of a really clean vodka and PG works "absolute" wonders. ;) When used in my ultrasonic parts cleaner at low heat things are beyond sparkling. A quick rinse and zero taste and/or odours remain.

edit: I mistakenly thought Wings was talking about PG here, but it has actually led to a bit of a revelation, so hats off! I still recommend my solution though, for others like me, so no change there. PGA is virtually impossible and in fact illegal without permits for the average consumer to buy here in BC, illegal to distribute as well so I will not be dropping any names here.

What is PGA?

Duane
 

TrueNorthist

I'm sorry, Dave. I'm afraid I can't do that.
ECF Veteran
Verified Member
Jan 4, 2012
560
976
Cariboo Country, BC
I'm livin on the edge, charging my RX200 via USB with the 1.08 firmware. Hah.
Get me the pentagon! And I want a 500 mile zone of exclusion put up around the entire state of Maryland stat! Ms Burns, get me the President on the phone!

 

TrueNorthist

I'm sorry, Dave. I'm afraid I can't do that.
ECF Veteran
Verified Member
Jan 4, 2012
560
976
Cariboo Country, BC
I just thought of something that might already have been bandied about... Does it make a difference whether one updates from say, 1.03 directly to 1.08 instead of installing them in sequence? ie: 1,03, 1.04, 1.05 etc. Just a thought, but maybe there can be issues created by jumping past earlier updates? Anybody think this is something worth wondering about?
 
Status
Not open for further replies.

Users who are viewing this thread