Your Dual Coil Headquarters! NEW! 2.5ml capacity Duals! 306's! KR808!

Status
Not open for further replies.

richham3

Senior Member
ECF Veteran
Aug 5, 2010
219
78
Taylor, Michigan
I know it's hard to tell. I filled my first one yesterday morning and six hours later it was still going strong. I was waiting for that first bad draw but decided to fill it up again, Took 100 drops to fill initially and only 65 to top it off again. Looking at it now I couldn't tell you how much juice is left but it's still going strong. Love the size and the mouthpiece. Also, I'm using this and the other 1.5 duals I have on either regular riva batteries or 3.7 SLB ego bats and they are great.
How do you know when the 3.5 clears need filling? The filler looks wet all of the time to me.
 

hairball

ECF Guru
ECF Veteran
Verified Member
Sep 17, 2010
13,110
7,459
Other Places
Received my 3.5ml duals today. I loaded one and put it on my Prodigy V3.1 at 3.7Vs. I was never one for TH or claim to know what a TH was. I figured after smoking all that I did, I burned my throat completely and it would never recover. The TH on these duals is hardcore. I think I'm going to need to buy some lower nic juice to put in them. I actually got light headed after 7 draws.

My only complaint is the drip tip. They need to be made of delrin and not rubber. Other than that, they work great IMO.
 

hairball

ECF Guru
ECF Veteran
Verified Member
Sep 17, 2010
13,110
7,459
Other Places
The TH decreases after initial use. The rubber provides a seal delrin can not.

Good point about the rubber. But they could use several o rings to make the seal.

Keep in mind, I bought 10 and have only been using 1 of them but is anyone having a problem with filling. What I mean is that when I top mine off, I literally have to lay it on it's side or the juice comes out the connector end. I'm being extremely careful that juice doesn't go down the airhole. What gives with it? I love the way they vape and the capacity but it boogles me as to the dripping out the hole when refilling this one. I guess I need to open another one and see if it does the same. I will keep buying them as I am really enjoying this one. If anyone else has experienced this, please post. I've been filling cartos for a long time so I know it isn't me just getting old....LOL.
 

gjrhine

Super Member
ECF Veteran
May 18, 2009
882
12
Sunny South Carolina
Good point about the rubber. But they could use several o rings to make the seal.

Keep in mind, I bought 10 and have only been using 1 of them but is anyone having a problem with filling. What I mean is that when I top mine off, I literally have to lay it on it's side or the juice comes out the connector end. I'm being extremely careful that juice doesn't go down the airhole. What gives with it? I love the way they vape and the capacity but it boogles me as to the dripping out the hole when refilling this one. I guess I need to open another one and see if it does the same. I will keep buying them as I am really enjoying this one. If anyone else has experienced this, please post. I've been filling cartos for a long time so I know it isn't me just getting old....LOL.

Having given up on tanks because of o-rings I prefer the rubber. It stays in place well also.

I actually fill slowly until juice comes out the connector. When I stop filling there are 2 or 3 more drops then I know it's full.
 

Bigbuyer

Unregistered Supplier
ECF Veteran
Sep 5, 2009
3,839
1,252
Florida, USA
They are clear. 1.5 ohms.

510_3.5ml_Dual_C_4dee88e4a0f87_90x90.jpg
 
Status
Not open for further replies.

Users who are viewing this thread