Mine bro, baybee.
(The temp was at its lowest, just by the way.)
(The temp was at its lowest, just by the way.)
That should not have happened regardless the 25W. Is it possible you were in Ni TC mode instead of SS TC?Just by the way, your mod allowed you to set the wattage to 12.5w. Mine allowed the LOWEST setting to be 25w. And I set my temp to the very lowest it would go. The end result? HOOOOOOOOOOOOT.
Katdarling, FWIW, this has been my standard TC troubleshooting regimen: First, I put down the spiteful TC set up that refuses to work right out of meanness and have a vape or two on a faithful stand-by that's familiar and broken in and just "gets me." This calms me down and is slowly replacing my previous first step, which was shouting "What is wrong with you?" at the TC set up in increasingly higher pitches until eventually summoning the dog. Sometimes, that's as far as I get for a day or two and I'm okay with that. Step two is to pick up the TC again whenever the spirit moves me and start over with a new coil and hope it works this time. I'm pretty new at this. Yeah, I know - it's not much of a regimen, but life is short and this is supposed to be enjoyable, right?
That should not have happened regardless the 25W. Is it possible you were in Ni TC mode instead of SS TC?
Anyway I strongly suggest a mod which allows you to set the max wattage. I find it quite unpleasant when the initial wattage is significantly higher than the average wattage applied.
This is the v3 Mini thread, right?![]()
What mod are you using for SS?
I stopped chasing the moment I found mine, right 'round three-fo' years ago.Oh yeah. The perfect vape is out there and the chase is always on.
Sent from my iPhone using Tapatalk
I'm with ya, Longolino.![]()
Oh yeah. The perfect vape is out there and the chase is always on.
Sent from my iPhone using Tapatalk
I've found the perfect vape is always chasing ME ... right to my bank accounts.![]()
For those using kanthal in your mini, what gauge are you using?
The problem ones only flood when you have the top off to fill them, other than that they don't leak.I have this being shipped…Ive seen a couple of reports report on the leaks due to the jfc not closing….is this problem easy to see before using the tank….I mean will I be able to see the jfc slots not closing fully or is it one of those hairline problems thats hard to make out.
If it's gonna leak, Id rather see the signs before hand rather than have it dump a load of juice on my lap.
Just fill it upside down...FT has shipped out my replacement base for the Plus 1.5, which has a 22.5mm diameter base and fits on the Pico perfectly.
The replacement base they are sending is this one which has a 23.5mm diameter and might not fit the Pico. It could be a typo from FT but I will update when it gets here. They shipped it out Singapore Post and that is usually 4-5 weeks getting here.
This is a fully closed defective unit for those that want an easy test to find out.
View attachment 579305