I think the coil master is the greatest.
where did you get em for a steal? I've got a v1, but would like to have one that is marked with the sizes. My eyes can't tell the difference between a 2.0 and a 2.5
I've had no issues with 30g if I use the 2.0 rod (pretty sure that's the one I'm using), and a very light touch, but I agree, I've had a lot of issue trying to do a 3.0 coil with 30g. finally got a couple done, but wasted a lot of wire.They don't do 29g or higher wire very well though IMO. The wire is just too flimsy
well poo! Thanks hunSorry, Deb - got 'em at a B&M.
Thanks, got that one on my wishlist, just not at the top of it since I do have one. Scott and I have been looking at that and we think it's the V2 since it appears it has the grub end on the driver rather than phillips, but wish it said for sure if they were marked.I'm not sure what version this one is - but here's this.
Walant Coil Master 5 in 1 Coiling Kit Kanthal Wire Jig Diy Kit Tool Set - - Amazon.com
I was sent 3 of the V3 and have these two available for my fellow REOnauts.
How bout I shoot YOU one if you would be so kind to email me a PDF of a USPS small flat rate box label that you will log into USPS.com to create with your mailing info on it that I can print and stick on the small flat rate boxes I have? I'll put them in the mail tomorrow
First two REOnauts that pm me for my email address and zip code get em. One for each of you
Crap....missed out again on some kewl stuff from kewl peeps....O well...anybody have a link where to buy a V3??
Stay tuned ya'll - the coil master guys (they are real cool to me) may be sending me more coil masters to give away. I'll update you as I learn more.
Stay tuned ya'll - the coil master guys (they are real cool to me) may be sending me more coil masters to give away. I'll update you as I learn more.
Grabbed one. Thanks for the link.I'm not sure what version this one is - but here's this.
Walant Coil Master 5 in 1 Coiling Kit Kanthal Wire Jig Diy Kit Tool Set - - Amazon.com
Wish they had a rod size that was compatible with my coil build I use a 16 gauge blunt needle = 1.65 mm for my 2mm RxW wick. 1.5mm a bit too small and 2.0mm a bit too large other wise I would jump all over one of these!
You might know this already, but the wire gizmo has a 1.65mm rod.