Eleaf Istick

Status
Not open for further replies.

underwhelmd

Super Member
ECF Veteran
Nov 22, 2014
463
6,831
Canada
Just a ridiculous picture I took today.

IMG_20141124_130216.jpg


of course this does not work. 1.8 x 2 = .9ohms which is .1 below what the istick will fire on. an error comes on the screen saying "too low". That sucks.


MY review of this eleaf istick battery after a couple days. YOUR MILEAGE MAY VARY. I was a fan the first night using this battery on a protank 2 with 2.2ohm coil. Not so much since. All of the negative things in that video review are true. On a fresh charge, it's over driving my 2.2 coils because it doesn't actually turn down as indicated on the display. This produces a vapour that is way too harsh/hot/burnt to me at the lowest setting the battery will do. I didn't notice this on the first night because it wasn't fully charged. It's a cooler vape on the second half of the charge. I'm comparing it to a VapeOnly 1600mAh 3.7V battery that makes the same voltage throughout it's charge life.

The form factor is very nice. That's why I bought it. The display is nice, if not accurate to reality.

So as it stands, I'm taking this back to the shop I bought it from and saying the above. This one is faulty or just not for me. It's all about the taste, right?

if I'm doing something wrong or not doing something I should be out of ignorance, then please feel free to correct me. Just not enjoying the vapour being driven by this battery.

unrelated: tried this on a Cloupor Cloutank M4. crazy. :ohmy:
 

dorkultra

Full Member
Oct 5, 2014
14
12
Pittsburgh
Nice! How did u keep it from leaking? Each time I tilt my Magma clone, some of the juices oozes out the air hole...

Not exactly the case. if i put it in my pocket, i rotate the ring to close off all the airholes. I noticed today that if i had the e-liquid well full, it would ooze out a little when i'd open the holes back up.

so, i don't keep the e-liquid well full and instead just soak the cotton wick
 

quinngia

Moved On
Sep 8, 2014
0
100
New York
  • Deleted by retired1
  • Reason: Unregistered Supplier
Status
Not open for further replies.

Users who are viewing this thread