Genesis Line - mini genesis
- Thread starter shpaolin
- Start date
- th_trl_thread_readers 0
- Status
how to drill a hole through the mesh when it is rolled, the surface is so small, what stick a needle through it???
Thats the way I would do it Bro, your only expanding an existing hole in the mesh
All the way through from one side of the mesh, throught the tube to the other side?
That is madness, a 1.2 mm mesh and then put a hole in it to fit a wire....i am not chinese!!
I am buying 510 stock atty. This is all to crazy. I was very happy with my
3.7v mod and my Line on it. Now i have to go to school again just for oxidizing mesh.
3.7v mod and my Line on it. Now i have to go to school again just for oxidizing mesh.
Emonty it a 1.2 mm needle you wrap the mesh tightly around and the mesh is 38 mm wide and the pic looks just right, go for it !!!
Both my lines work well on my Provari, just some fluctuation with the ohms which we know about , emonty will report back soon on the success of the needle and threadingI am buying 510 stock atty. This is all to crazy. I was very happy with my
3.7v mod and my Line on it. Now i have to go to school again just for oxidizing mesh.
This is madness, got the wire through the hole, then to wrap it tightly you need to put back the syringe then wrap, but the wire is now through the hole and the syringe does not fit into the mesh anymore. I ripped it all apart, through it against the wall and sitting down with my HH 357 vaping...this is ridiculous, nobody will do this. Only if you drink local raki made from an ancient root which only grows every 1000 years when there is an eclipse....I have not the patience to go through this...maybe tomorrow....
So you all are not happy and your Lines are giving you trouble?? I like mine seems to be working good . I had to reroll the mesh twice and redo the coil to make it tighter and now its working good. I think it works better at 4.2 than 3.7 so alittle bummed about that but most I like it.
- Status
Similar threads
