Genesis RBA on a ProVari

[michaelsil1]

I used a 1-1/2 x 3" piece. I rolled it up as tight, as I could. There is just the tiniest hole, which is visible in the center.

I pre-oxidized it prior to rolling and hit it with a torch again after rolling it.

- Andy . . . Embrace the day.

Thank you,

I was thinking the same thing put it on a paper clip and roll it as tight as I can, I can really roll tight I've had a lot of practice.

 

[michaelsil1]

Finally found my sweet spot on the AGA T2. I have them dialed in with #500 SS mesh, 3/4 wrap w/30g Kanthal @ 1.3 ohms . . . Yes!

I had been playing with higher resistance coils and then realized that I like the vape with my lower initial set-up. I have had quite a bit of fun playing with these guys. This is definitely a hobby, which I am going to enjoy. When its time to change one of the coils out, I am going to try using SS wire rope.

A smoktech rsst and 2 IGO-Ls should be here, soon. Cannot not wait for those to show up and tinker some more.




- Andy . . . Challenge the day.

I received my 500 SS Mesh and 30g, but AGA-T2 is working so well with the 400ss and 32g I can't bring myself to tear it down and redo.

 

[eratikmind]

I received my 500 SS Mesh and 30g, but AGA-T2 is working so well with the 400ss and 32g I can't bring myself to tear it down and redo.

If it ain't broke, simply enjoy it. Happy provaping.


- Andy . . . Challenge the day.

 

[michaelsil1]

If it ain't broke, simply enjoy it. Happy provaping.


- Andy . . . Challenge the day.

Thank you,

I needed to hear that!

 

[hadouken]

If it ain't broke, simply enjoy it. Happy provaping.


- Andy . . . Challenge the day.

and if the Provari isnt broke, don't hesitate to buy another.