Discussion in 'The GG' started by imeothanasis, Jun 12, 2011.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
ahahaha, thats great houm.!
I was using my UFS last night and it instantly started leaking heavily into the collection tank and flooding the atomizer. I took the whole unit apart and realized that the connector pin is missing 2 o rings I checked out this thread and see that I need the 2mm/1mm for inside the pin and 4mm/1.5mm for the outer part of the pin. I have searched this forum and google high and low and can not find any site that sells both o rings. oringsUSA has the 2mm/1mm but not the 4mm/1.5mm. They do have a 4mm/1mm do you think that will still be sufficient. If not can someone tell me a site where I can just buy these things in bulk and not have to worry about it again. I am going to try ace hardware after work but I think that may be a longshot. Any help much appreciated. Thanks.
Nevermind I did not see the 4mm/1.5mm towards the bottom . oringsUSA does have everything you should need for the UFS
edit: after I purchased I found this site http://www.mcmaster.com/ you can get 10 times the amount for the same price.
Ditto.....so now I have 200 coming in.....oops
Good stuff guys!
Thanasi from iatty missing the under the center post o-ring
its a 3X2mm but 3X1,78 work fine also
I never used an o-ring there louk, its not nessesary
What is the size and material of the Ithaka Insulator Plastic i am going to pick up some o-rings thought i might be able to get a few plastic insulators as well thanks ahead of time . adam
I corrected esterigon's o-rings
Hey Guys, hello Imeo,
Could someone post the O-ring list for the GG4S, just in case...
sure bb, thanks a lot for the reminder. I will do it now
You're welcome Imeo!
I receive my GG4S next wednesday if tracking is right, and even if I don't plan to lose an O-ring soon, it happened on a french forum, so I could give to link to this thead, that may help...
great move bb
also I forgot the o-ring around the AD cap where the AD ring sits. Its a 14x1
Thanks for adding the list Imeo!
To be honest, on the video, I was a bit worrying about the reliability of the brass contact/switch o ring, because it's tightly flatened, but now I have seen one for real, and how fat it is, I don't worry anymore...
Is it possible to get the specs for the Tilemahos V2 22mm o-rings this would help a lot Thanks Adam
sure Adam, in a minute buddy
which material are the GG o-rings made of? I need two for my new Tilemahos brass AD Ring. I didn't know that the AD Ring comes without o-rings ;-)
But i can get two o-rings in my company.
But there i can choose between following materials:
Thanks and Greetings from Germany
AD ring comes with o-rings Entry. Your seller just forgot them. By the way, you can buy NBR o-rings. Thats what I use
Anyway, every time you buy a GG construction or spare, better buy a set of o-rings. They are very cheap
all brass parts I purchased for estirigon and tilemahos came without o-ring either ... it's a pitty since I'm part of those thinking it would be included for sure ...
I always send the nessesary o-rings to my sellers monk. Yes its a pity. Let me send an e-mail about this issue to all my sellers to be sure that this will not happen again
Separate names with a comma.