I think I should try a spheroid.
I have always been put off by the long narrow look but have read nothing but good things about it.
- Status
I think I should try a spheroid.
I have always been put off by the long narrow look but have read nothing but good things about it.
Hmmm... I got a confirmation email showing shipping paid but no shipping notice.
Interesting, that you could check out without paying for shipping. Seems like it was part of the ordering process.?
Interesting, that you could check out without paying for shipping. Seems like it was part of the ordering process.?
Honestly you will love it. I am going on 3+ weeks on my eko setups. I rinse wick and fluff out when I change up flavors and poof I'm vaping again. It is the only setup that I leave the home with also. It is also impossible to damage them.
4 wraps .30 on 2mm eko in a small figure 8 = 1.2ish ohms.
wicking is an issue that many have but it typically is from the overuse of fill. The less the better. Check out GP tip thread.
My UK friend...Idaho is telling you the truth. The only thing I can't figure out is how he came into possession of my top secret build..humm? I'm embarrassed by the number of high end atomizers I own, but if I could have only one (like in case of the zombie apocalypse) it would be the spheroid sitting on top of a Paps SS 2.5
16mm x 50 mm I think.
A few of my pics, some have seen them.
It doesnt get better than Spheroid.
A few of my pics, some have seen them.
It doesnt get better than Spheroid.
Its length is 49 mm, 45 mm without the 510 connection and OD is 16 mm, the same as the GP Piccolo.
I'm guessing that the packaged Divers have flanges, as the tank is made to accommodate the said. For whatever reason, the flange-less Divers are made in small amounts, as requested by a few of us.
Konstantinos has noted that he personally thinks the the flanged Divers are easier to work with. I have 2 of each. Depending on the top cap of some mods, it really doesn't matter.
- Andy
Konstantinos has noted that he personally thinks the the flanged Divers are easier to work with. I have 2 of each. Depending on the top cap of some mods, it really doesn't matter.
- Andy
hey all, been super busy this weekend but got a couple rebuilds in on saturday morning... my gf traded her steam turbine Ti to her best freind for her ithaka for the weekend to see if she wanted one, and i was trying to show her how to set it up with the res/no res wires, with ekowool and mesh under the coils in dual coil mode (shes never done the res/nores before) after looking back at it she and i were laughing about how it would be funny as hell to have video taped it, screw all those perfectly recoreded ones of people wrapping coils.... one of me and my gf yelling at each other for 15-30 mins
"here, hold this while i do that" "this?" "no hold that" "not this?" "no dammit, that" "this??" "you dropped it, and I told you to pull on the thingy" "what thingy?" "the damn thingy thats on the floor now, no not the thick one the thin one" "well point to it next time" "i cant" "cant what?" "nevermind, alright pull that over this" "point to what you want i dont know *that*, and *this*" "I nodded towards it" "nodded towards what? which one, point to it" "Well, dammit, I would if my hands were free but i cant bc you wont hold the thingy f.... no @$%*( dont do that" "do wut?" "what you just did" "huh?" "what you just did, dont do that you almost ripped the wick, now its frayed on the mesh..." "I was trying to help" "its not helping"
... and somehow we end up with a perfectly wrapped dual coil set up at the end, lol. also I know blake, hes a good dude and a buddy im sure he'll get his webstore set up proper.
"here, hold this while i do that" "this?" "no hold that" "not this?" "no dammit, that" "this??" "you dropped it, and I told you to pull on the thingy" "what thingy?" "the damn thingy thats on the floor now, no not the thick one the thin one" "well point to it next time" "i cant" "cant what?" "nevermind, alright pull that over this" "point to what you want i dont know *that*, and *this*" "I nodded towards it" "nodded towards what? which one, point to it" "Well, dammit, I would if my hands were free but i cant bc you wont hold the thingy f.... no @$%*( dont do that" "do wut?" "what you just did" "huh?" "what you just did, dont do that you almost ripped the wick, now its frayed on the mesh..." "I was trying to help" "its not helping"
... and somehow we end up with a perfectly wrapped dual coil set up at the end, lol. also I know blake, hes a good dude and a buddy im sure he'll get his webstore set up proper.
Last edited:
I just replied this at VW...
qorax said:Both, the Paps v2.5 SS and the GP Lux, are my favourite mods. Typically I'm a GP guy - b'coz they are so reliable, built well, looks gr8, are the smallest 18350 devices in the market as of now AND soberly priced.HCCVapes said:
That said, for a usual vaper, you wouldn't find any difference between the v2.5 SS and the Lux! Both would fire similarly for most Attys atop. Both would give you the same vape quality against most of the RBAs/Tanks you have. The difference is unnoticeable!
However, the difference, though not much, yet could be understandable and felt when you are either (1)a "senior/serious vaper" or (2)using sub-ohm coils (anything under 1.1 Ω). B'coz, the GP Lux gives conductivity a very new meaning! Combining a smart/Pioneering body tube (Alu-Bronze) with those 24K Gold over Silver Plated contacts, the Lux has a near "0" Voltage Drop!
If you had read my review of the GP Lux you'd know that without load I had a mere 0.1-0.2V drop. And under load, with a 0.9-1.1 Ω RBA, the voltage drop was again peanuts, just 0.2-0.3V. And these I was testing with only 18350 bats, freshly charged, which were typically doling out around 4.17Vs.
Yes, that good the GP Lux is.
However, with a meagre 0.3V drop (without load), the Paps v2.5 SS is just as good!
- Status
Similar threads
- Locked
