- Status
So when are the spheroids going to be available again? Would prefer to buy direct.
Agreed, but I'm having fun with an AC9 on my Paps, the Spheroid will be later on, unless they come up with a Genisis Paps, then I'll be all over it,
Hi NB, I went ahead and ordered this just now:
PRICE: $10 (peanuts!)
WHERE: eBay
Thanks for the tip once again
Hi NB, I went ahead and ordered this just now:
PRICE: $10 (peanuts!)
WHERE: eBay
Thanks for the tip once again
Nice buy! I'm having trouble deciding on one for myself.... lol
Hi Guys,
Need some help, I am having hot button from my 2.5 paps, some information as below.
using 0.9 ohm.
18350 battery.
took apart the switch, spring seem ok.
clean contact point.
Any idea if this is normal for hot button?
best regards,
Aaron
Need some help, I am having hot button from my 2.5 paps, some information as below.
using 0.9 ohm.
18350 battery.
took apart the switch, spring seem ok.
clean contact point.
Any idea if this is normal for hot button?
best regards,
Aaron
When the resistance value is below 1Ω it is possible to happen, though you have to check whether a short occurs to the atomizer, or the battery is peeled off somewhere.
Dear perseas, thank you for your quick reply, have check that there is no short and no peel off, good to know that it normal when the resistance value is below 1Ω.
^Yep, it is normal with all mods when the topper is sub-ohm or around it. Especially when using in 18350 mode.
I use around 0.9-1.1Ω and the LUX get's warm while chain-vaping (nearly), while my Paps-SS do to - but after a tad longer pd - b'coz it's in 18650 mode.
I use around 0.9-1.1Ω and the LUX get's warm while chain-vaping (nearly), while my Paps-SS do to - but after a tad longer pd - b'coz it's in 18650 mode.
In my opinion, the silika atties like Iatty, Ithaca, Penelope, Odysseus, Spheroid do their best work between 1,5 - 1,8 Ω, preserving the battery's life longer while they give a balanced mix of decent throat hit, rich flavour and satisfying vapour.
The genesis atties, especially those with poor designed top caps (air chambers) and large air holes they need subzero resistances to match the same results. From the moment I sell a silica atty, take my comments with a grain of salt.
The genesis atties, especially those with poor designed top caps (air chambers) and large air holes they need subzero resistances to match the same results. From the moment I sell a silica atty, take my comments with a grain of salt.
Grain of salt maybe but, it exactly mirrors my experience. I prefer bottom coil silica devices for partly that reason.
I consider a well designed bottom coil genesis atty will have possibly the merits of both worlds, silica and genesis atties.
Not as nice as the leather ones but if you are out on a more tactical outing such as hiking, bouldering or whatev look at Mini Maglite or flashlight holders such as this maybe. My pockets seem to be my choice so far
Rothco AA Mini Maglite Holder, ArmyGuyz.com
- Status
Similar threads
- Locked
