Sorry about that rebar - I do still have your Reo Mini holster on my list of things to try to put together. I've got one big project to (hopefully) finish this week, and then I might be able to get to some of these other mod holsters that folks have been asking about.
Just so everyone understands; if I don't reply to requests for holsters for specific mods right away, it's because the only way I know if I can make one is to try it, and that's a little tricky with mods I don't own. I have to get accurate measurements, then make a wooden form, then work up a pattern and then actually make a holster to ensure that the pattern is good, and it usually takes at least two tries to get it just right.
I figure it takes roughly four hours to get a basic pattern worked up, and then it takes about an hour and a half of actual work time to put one good holster together from the final pattern (plus six to eight hours of drying time). Then I have to sell two of the holsters just to cover the cost of materials involved in working up the pattern.
This is a fun hobby but it's not really a very good business model...
Therefore, that would not a problem, although I suppose it would need a slot down one side for the button to slide down; also, the newer versions have a lower-rise button. OK, will get on the dimesion thingy -- cool!
